Renkforce 1325938 Owner's manual

Brand: Renkforce

Model: 1325938

Type: Owner's manual

Renkforce 1325938

Dummy camera with night light. The product looks deceptively similar to a functional surveillance camera and is therefore used as a deterrent in areas that are difficult or critical to see (e.g. stairwells, entrance areas, shops, etc.). The dummy camera is intended for mounting and operation on a ceiling indoors and outdoors. The dummy camera is powered by 2 AA/Mignon batteries (not included, can be ordered separately). When it is dark (ambient brightness <30 lux), a PIR sensor is active.

Renkforce 1325938

Page is loading ...

Battery/rechargeable battery instructions

• Batteries/rechargeable batteries must be kept out of the reach of children.

• Do not let batteries/rechargeable batteries lie around openly. There is a risk of bat-

teries being swallowed by children or pets. If they are swallowed, consult a doctor

immediately.

• Acid contact due to leaking or damaged single/rechargeable batteries can burn

your skin, therefore use suitable protective gloves.

• Liquids leaking from batteries/rechargeable batteries are very chemically aggres-

sive. Objects or surfaces coming into contact with these liquids could be consider-

ably damaged. Thus, store batteries/rechargeable batteries in a suitable location.

• Normal/rechargeable batteries must not be short-circuited, opened or thrown into a

ﬁre. There is a risk of explosion!

• Do not recharge normal, non-rechargeable batteries; there is a risk of explosion!

Only charge rechargeable batteries that are intended for this purpose; use a suit-

able battery charger.

• Never mix standard batteries with rechargeable batteries, use either standard bat-

teries or rechargeable batteries.

• Do not mix batteries/rechargeable batteries with different charge levels (e.g., full

and half-full batteries/rechargeable batteries).

• Always replace the complete set of batteries/rechargeable batteries.

• Check that the polarity is correct when inserting the batteries/rechargeable batter-

ies (pay attention to plus/+ and minus/-).

• If you wish to use rechargeable batteries, please note that, due to the lower output

voltage (batteries = 1.5 V, rechargeable batteries =1.2 V), the operating time will de-

crease. Especially at low temperatures, the operating time drops signiﬁcantly with

rechargeable batteries.

Therefore, we recommend that you use high-quality alkaline batteries to operate the

dummy camera in order to ensure long-lasting and reliable operation.

Inserting/replacing the batteries

• Open the battery compartment of the dummy camera and insert two AA batteries

(mignon) paying attention to the correct polarity (pay attention to plus and minus).

• Close the battery compartment again.

• A battery change is necessary when the white LEDs no longer light up at night.

Assembly

• Select a suitable mounting location for the dummy camera. During installation, keep

the desired alignment of the camera opening in mind.

The product is designed for use indoors and outdoors. Outdoors, however, mount it

at a location protected from direct precipitation (e.g. under an overhang).

The screw or drilling position can be selected optimally using the provided

installation template.

Please make sure that you do not damage existing cables or wiring when

drilling/screwing into place.

• Screw in two screws such that each screw head still stands out approx. 3 mm.

• Set the dummy camera on the screws and turn it a little way to the right.

If necessary, adjust the screws so that the dummy camera can be correctly

set and locked on them.

This makes it very easy to change the batteries without needing tools to

remove the camera.

Function

The LEDs of the dummy camera are controlled by a PIR sensor located in the centre at

the position of the camera lens.

The PIR sensor is active only at low ambient brightness (< 30 lux), so that the

LEDs are not switched on unnecessarily during the day.

The PIR sensor recognizes temperature changes in the detection area, such as when

a person or an animal enters the detection area.

The weak white lighting of the LEDs simulates a function of the camera.

When the PIR sensor no longer recognizes a temperature change in the detection

area, the white LEDs turn off automatically.

Only 12 LEDs light up (the inner ring of LEDs); the others (the outer ring of

LEDs) are only functionless dummies.

Operating instructions

Dummy camera with nightlight

Item no. 1325938

Intended use

The product looks deceptively similar to a functional surveillance camera, and there-

fore, it can be used for deterrence in secluded or critical areas (e.g., driveways, en-

trance areas, shops, etc.).

The dummy camera is intended for installation and operation on a room ceiling in in-

door and outdoor areas.

The power supply for the dummy camera is via 2 batteries of type AA/Mignon (not

included, available separately).

In darkness (ambient brightness <30 lux), a PIR sensor is active. This recognizes tem-

perature changes in the detection area and then activates 12 white LEDs for several

seconds. The weak white lighting of the LEDs in the night simulates a function of the

camera.

Always observe the safety instructions and all other information included in these op-

erating instructions.

This product complies with the applicable national and European requirements. All

names of companies and products are the trademarks of the respective owners. All

rights reserved.

Package contents

• Dummy camera

• Installation material (2 screws, 2 wall screw-plugs)

• Warning sticker

• Installation template

• Operating instructions

Explanation of symbols

This symbol indicates speciﬁc risks associated with handling, operation or

use.

The “arrow” symbol points to special tips and operating information.

Safety instructions

Damage due to not following these operating instructions will void the

warranty! We do not assume any liability for any resulting damage!

We do not assume any liability for material and personal damage caused

by improper use or non-compliance with the safety instructions. In such

cases, the warranty will be null and void.

• The unauthorised conversion and/or modiﬁcation of the product is not

permitted for safety and approval reasons (CE).

• The product is designed for use indoors and outdoors. Outdoors, however,

mount it at a location protected from direct precipitation (e.g. under an

overhang).

• The product is not a toy and does not belong in the hands of children.

Install and use the product where it is out of the reach of children.

• Do not operate the device in environments where there are high levels of

dust, ﬂammable gases, vapours or solvents. There is a danger of ﬁre and

explosion!

• Do not carelessly leave the packaging material lying around since this

may become a dangerous toy for children.

• Handle the product with care; it may be damaged by impacts, blows, or

accidental falls, even from a low height.

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method, e.g. photocopy, microﬁlming, or the capture in electronic data

processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent

the technical status at the time of printing.

Maintenance and cleaning

Maintenance or repair work may be performed only by qualiﬁed personnel or a spe-

cialised repair shop. The product contains no parts that require servicing. Therefore,

do not open/dismantle it (except to replace the batteries).

Use a clean, dry and soft cloth for cleaning. Do not apply too much pressure on the

housing (especially the transparent cover); this could result in scratch marks.

Do not use abrasive cleaning agents, cleaning alcohol or other chemical solutions,

since these could damage the housing or even impair operation.

Disposal

a) General

Please dispose of the unserviceable product according to the relevant stat-

utory requirements.

Remove any inserted battery/rechargeable battery and dispose of it sepa-

rately from the product.

b) Batteries and rechargeable batteries

As the end user, you are required by law (Battery Ordinance) to return all used bat-

teries/rechargeable batteries; disposal of them in the household waste is prohibited.

Batteries/rechargeable batteries containing hazardous substances are la-

belled with this symbol to indicate that disposal in domestic waste is pro-

hibited. The designations for the heavy metals involved are: Cd = Cadmium,

Hg = Mercury, Pb = Lead.

Used batteries, rechargeable batteries as well as coin cells can be returned to collec-

tion points in your municipality, our stores or wherever batteries/rechargeable batter-

ies/coin cells are sold.

You thereby fulﬁl your statutory obligations and contribute to the protection of the

environment.

Technical data

Power supply ...................................... 2 batteries of the type AA/Mignon

Battery service life............................. depends on the frequency of LED activation,

approx. 1 year

Number of lighting LEDs ................... 12 (white)

PIR range ............................................. approx. 3 m

PIR detection angle ........................... approx. 125° - 138°

Swivel range of the camera ............. 45°

Rotation range of the camera .......... 360°

Protection grade ................................ IPX3

Ambient conditions ............................ temperature -20 °C to +75 °C, relative humidity 0%

to 80%

Dimensions.......................................... 97 x 70 mm (Ø x H)

Weight .................................................. approx. 130 g (without batteries)

Page is loading ...

Renkforce 1325938 Owner's manual

Brand: Renkforce

Model: 1325938

Type: Owner's manual

Renkforce 1325938

Download PDF

report

in other languages

français: Renkforce 1325938 Le manuel du propriétaire
Deutsch: Renkforce 1325938 Bedienungsanleitung
Nederlands: Renkforce 1325938 de handleiding

Renkforce 1325938 Owner's manual

Renkforce 1325938 Owner's manual

in other languages

Related papers

Other documents