Dometic ECO Holding Tank Vent Filter User manual

Page is loading ...

2

ECO Vent Filter

1

3

2

Notes on using the manual

3

1 2 3 4

4

4 3 26

5

5a

5b

5c

1

3

ECO Vent Filter Notes on using the manual

4

ECO Vent FilterNotes on using the manual

Table of contents

1 Notes on using the manual .................................................4

2 General safety instructions .................................................5

3 Intended use ............................................................5

4 Installation ...........................................................5 - 6

5 Warranty ............................................................6 - 7

6 Customer service.........................................................7

1 Notes on using the manual

Caution!

Safety Instruction: Failure to observe this instruction can cause material damage and

impair the function of the device.

Note

Supplementary information for operating the device.

ﬁg. 1, p. 2 : This refers to an element in an illustration. In this example, item 1 in

gure 2 on page 2.

2

EN

5

ECO Vent Filter General Safety Instructions

2 General safety instructions

The manufacturer will not be held liable for claims for damage resulting from the following:

• Faulty assembly or connection

• Damage to the unit from mechanical inuences

• Alterations to the unit without express written permission from the manufacturer

• Use for purposes other than those described in the operating manual

3 Intended use

When a toilet is ushed on a boat with a holding tank, air is pushed out of the holding tank, through

a vent hose, and out of the boat through a vent tting. To stop foul-smelling air from coming out of

the vent tting, install an ECO Vent Filter.

4 Installation

Remove old ﬁlter (if replacing existing vent lter)

1. Remove vent hose from both ends of old vent lter. If old vent lter was connected to threaded

ttings for 5/8-in./16 mm or 3/4-in./19 mm ID hose, those ttings should remain attached to vent

hose.

2. Remove old lter from bracket and seal ends with adhesive tape.

3. Discard old lter in appropriate container.

Install ﬁlter

NEW INSTALLATION

1. Select location for vent lter. Avoid areas near excessive heat sources (engine manifolds,

lights, etc.). Do not install lter below top of holding tank (g.

1

p. 2).

2. Vent lter can be mounted at any angle. Installations near thru-hull vent reduce chance of lter

damage from potential overlling of tank.

3. Install mounting bracket (g.

2

1, p. 2) with screws (g.

2

2, p. 2).

4. Lightly lubricate O-rings on each end of lter cartridge with silicone grease.

5. Remove red plugs from each end.

6. After vent hose ID is chosen, attach correct size hose adapters (g.

3

5b or 5c, p. 2) to lter

cartridge with retaining fasteners (g.

3

4, p. 2). Be sure to push hose adapters completely

over O-rings before threading the retaining fasteners to the lter. Refer to Adapter Size Chart

below to identify correct size hose adapter.

7. Press ECO vent lter (g.

3

6, p. 2) into mounting bracket so that it clicks into bracket arms.

8. Route vent hose from waste holding tank and thru-hull tting to ECO vent lter. Using hose

clamps (not included), attach vent hoses to adapters that are connected to vent lter.

Ref. Description

4 Retaining fasteners

5a threaded adapters for 5/8-in. or

3/4-in. ID hose threaded ttings

5b 5/8-in.+3/4-in. ID hose adapters

5c 1-in.+1.5-in. ID hose adapters

Adapter Size Chart (g.

3

, p. 2)

Hose adapter

connection zones for:

5/8 in./16 mm ID hose

3/4 in./19 mm ID hose

1 in./25 mm ID hose

1.5 in./38 mm ID hose

5b

5c

6

ECO Vent Filter

Installation / Warranty

5 Warranty

North America and Rest of the World:

Manufacturer’s One-Year Limited Warranty

Dometic Corporation, Sanitation Division warrants to the original purchaser only that this product,

if used for personal, family or household purposes, is free from defects in material and workman-

ship for a period of one year from the date of purchase.

If this Dometic product is placed in commercial or business use, it will be warranted to the original

purchaser to be free of defects in material and workmanship for a period of only ninety (90) days

from the date of purchase.

(continued on next page)

REPLACING OLD SEALAND OR DOMETIC VENT FILTER

For installations with 5/8-inch or 3/4-inch (16 mm or 19 mm) ID hose threaded ﬁttings (g.

3

3, p. 2) already attached to vent hose:

1. Make sure rubber gaskets (not provided) are inside threaded ttings at hose ends.

2. Lightly lubricate O-rings on each end of lter cartridge with silicone grease.

3. Remove red plugs from each end of lter cartridge.

4. Use retaining fasteners (g.

3

4, p. 2) to attach threaded adapters (g.

3

5a, p. 2) to each

end of lter cartridge. Be sure to push hose adapters completely over O-rings before threading

the retaining fasteners to the lter.

5. Press ECO vent lter (g.

3

6, p. 2) into mounting bracket so that it clicks into bracket arms.

6. Attach threaded hose ttings to threaded adapters (g.

3

5a, p. 2) on lter cartridge. Tighten

1/4 to 1/2 turn beyond hand tight.

For installations with 5/8-inch, 3/4-inch, 1-inch or 1.5-inch ID vent hose and clamped

connection to vent ﬁlter:

1. Lightly lubricate O-rings on each end of lter cartridge with silicone grease.

2. Remove red plugs from each end of lter cartridge.

3. Use retaining fasteners (g.

3

4, p. 2) to attach correct size hose adapters (g.

3

5b or 5c, p.

2) to lter cartridge. Be sure to push hose adapters completely over O-rings before threading

the retaining fasteners to the lter. Refer to Adapter Size Chart (p. 3) to identify correct size

hose adapter to use with existing vent hose ID size.

4. Press ECO vent lter (g.

3

6, p. 2) into mounting bracket so that it clicks into bracket arms.

5. Using hose clamps (not included), attach vent hoses to adapters that are connected to vent

lter.

Caution!

Do not use ECO Vent Filter for holding tanks with waste that is treated through on-

board sewage treatment systems that use chlorine or other strong oxidizing agents.

Caution!

Replace vent lter immediately if accidental overow of holding tank occurs.

Note

Replace vent lter at the beginning of each boating season for best odor control.

7

ECO Vent Filter Warranty / Customer Service

Dometic reserves the right to replace or repair any part of this product that proves, upon

inspection by Dometic, to be defective in material or workmanship. All labor and transportation

costs or charges incidental to warranty service are to be borne by the purchaser-user.

EXCLUSIONS

IN NO EVENT SHALL DOMETIC BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES,

FOR DAMAGES RESULTING FROM IMPROPER INSTALLATION, OR FOR DAMAGES CAUSED

BY NEGLECT, ABUSE, ALTERATION OR USE OF UNAUTHORIZED COMPONENTS. ALL IMPLIED

WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS

FOR ANY PARTICULAR PURPOSE, ARE LIMITED TO A PERIOD OF ONE YEAR FROM DATE OF

PURCHASE.

IMPLIED WARRANTIES

No person is authorized to change, add to, or create any warranty or obligation other than that

set forth herein. Implied warranties, including those of merchantability and tness for a particular

purpose, are limited to one (1) year from the date of purchase for products used for personal,

family or household purposes, and ninety (90) days from the date of purchase for products placed

in commercial or business use.

OTHER RIGHTS

Some states do not allow limitations on the duration of an implied warranty and some states do

not allow exclusions or limitations regarding incidental or consequential damages; so, the above

limitations may not apply to you. This warranty gives you specic legal rights, and you may have

other rights which vary from state to state.

To obtain warranty service, rst contact your local dealer from whom you purchased this product

or go to http://www.dometic.com for a dealer near you.

6 Customer service

Contact information

There is a strong, worldwide network to assist in servicing and maintaining your toilet system.

For the Authorized Service Center near you, please call from 8:00 a.m. to 5:00 p.m. (ET) Monday

through Friday.

You may also contact or have your local dealer contact the Parts Distributor nearest you for quick

response to your replacement parts needs. They carry a complete inventory for the Dometic prod-

uct line.

Telephone: 1 800-321-9886 U.S.A. and Canada

330-439-5550 International

Fax: 330-496-3097 U.S.A. and Canada

330-439-5567 International

Web site: Dometic.com

Page is loading ...

18

REVISION A

Form No. 600347170 7/17

Dometic Corporation, Sanitation Division

13128 State Rt. 226, P.O. Box 38

Big Prairie, OH 44611 USA

1-800-321-9886 • Fax: 330-496-3097

www.Dometic.com

Dometic ECO Holding Tank Vent Filter User manual

Dometic ECO Holding Tank Vent Filter User manual

in other languages

Related papers

Other documents