G6 Internal Side Return Filter Retainer
Figure 1.
.75"
.75"
INSTALLATION INSTRUCTIONS
Filter retainer may be used for internal left or right side return
air filters. Drill two, 1/8" holes in the rear panel of the furnace
at the locations shown for either right side or left side return.
Install the ends of the filter retainer in holes as shown below
for right side return (opposite for left side return). The front
of the retainer snaps behind the front vertical flange in the
cabinet side.
7076530
Specifications & illustrations subject to change without notice or incurring obligations (06/15).
O’Fallon, MO, © Nortek Global HVAC LLC 2015. All Rights Reserved.