Intertherm Hail Guard Kit Installation guide

Hail Guard Kit

1. Measure the height and length of the visible coil surface.

2. Trim Hail Guard to the appropriate height and length.

3. Line up edge of mesh with the edge of the sheet metal and attach to the Coil Guard with the

cable ties provided.

4. Pull mesh around the unit and attach at opposite end with additional cable ties. Use additional

cable ties as required along mesh length to hold it snug to the Coil Guard.

INSTALLATION INSTRUCTIONS

7078000

Speciﬁcations & illustrations subject to change without notice or incurring obligations (07/15).