BR200BT / BR800BT Bluetooth Pairing with iPad
Save this guide as it may be needed to for pairing again in
case iPad lose the pairing information
The BR200BT and BR800BT Bluetooth Barcode Scanners work with
HID Keyboard emulation for operations with iPad. It functions like
there is a keyboard connection. Before the scanner works with the
iPad, Bluetooth pairing is required.
1. Power on the scanner by holding down the trigger button for 2
seconds.
2. On the iPad, click the "Settings" icon.
4. Click "Bluetooth" to display the Bluetooth menu. If Bluetooth is
off, click on the slide button to turn it on.
5. The scanner should be on the list of discovered devices. The
device name of the scanner is BR200BT or BR800BT.
6. Select the device and you will be prompted to enter paring pin
code.
7. Scan the barcodes on the right to enter the required pin code
displayed on iPad. Scan the "Enter" bar code to finish entering the
code. A short beep will sound upon connection.
Enter
8. After pairing is done, scanned barcodes will be entered into the
iPad application software as if they are typed from a Bluetooth
keyboard.
For more detail settings of other configuration parameters, please
refer to the User Manual.
/
