FMI ETL-12D Operating instructions

FMI
Brand
FMI
Model
ETL-12D
Category
Fireplaces
Type
Operating instructions

This manual is also suitable for

36"
Minimum
3"
Minimum
2"
Minimum
Square Top TerminaTionS
INSTALLATION INSTRUCTIONS
ETL-12D, ETL-12DMP, STL-12D AND STL-12DMP
1. Construct chase as illustrated in Figure 1.
Note: The shortest vertical side must be at least 30" high
and minimum inside dimension must be at least 19" as
shown in Figure 1.
2. Addpipesectionstochimneysystemasoutlinedinre-
place installation instructions until last piece of chimney
is a maximum of 6" below top of chase (see Figure 1).
3. Fabricateaashinghavinga16.5"diameterholecen-
teredoverchimneyendwitha2"collararoundhole(see
Figure 2). Attach noncombustible spacers at each corner
andplaceashingoverchase.
4. Secureashingthroughsideswith8-pennynailsorsheet
rock screws.
5. Place galvanized sleeve through hole in ashing and
around last section of chimney (see Figure 3).
6. Place termination cap over opening and slip stainless
steel inner pipe into stainless steel chimney section.
Lowerterminationassemblyuntilcaprestsevenlyover
ashinghole.Securecapateachcornerwithsheetmetal
screws (see Figure 4).
Figure 1 - Constructing Chase
Figure 2 - Constructing Chase Top Flashing
Figure 3 - Installing Termination Cap
Figure 4 - Securing Termination to Chase Top Flashing with
Sheet Metal Screws
As Required
28GaugeGalvanizedSteel
2" Collar
1" Noncombustible Spacer
Chase Top
Chase Facia
10 Foot Rule
Thechimneyuegasoutletofterminationmustbeamini-
mumdistanceof3feetabovethehighestpointwherepipe
penetrates the roof and must be a minimum distance of 2 feet
abovehighestpointoftheroofwithinahorizontaldistanceof
10feet(seeFigure5).
19"
Minimum
6" Maximum
30" Minimum
Termination
Cap
1" Spacer
Note: Do Not
Seal Ventilation
Openings
Screw
Galvanized
Sleeve
NOTAUPC
Figure 5 - 10 Foot Rule
Level of Flue
Gas Outlet
3' Min.
10'
or Less
2' Min.
Termination
16.5"Diameter
Sheet Metal Screw
110307 01
110307-01
Rev.E
05/08
DESAHeating,LLC
2701IndustrialDrive
BowlingGreen,KY42101
www.desatech.com
1-866-672-6040
Note: Do Not
Seal Ventilation
Openings
1" Space
1/4"Screen
  • Page 1 1

FMI ETL-12D Operating instructions

FMI
Brand
FMI
Model
ETL-12D
Category
Fireplaces
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents