2. RTS
  3. Kp 12 cld gpio option

RTS Kp 12 cld gpio option User manual

  • Hello! I am an AI chatbot trained to assist you with the RTS Kp 12 cld gpio option User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
KP 12 CLD GPIO Option Expansion Unit
Installation Instructions
IMPORTANT: Once you have finished installing the GPIO Expansion Unit, you must perform a Reset Cfg on the unit.
To install the KP 12 CLD GPIO Expansion Panel, do the following:
1. On the rear of the KP 12 CLD, remove the two (2) hex screws on either side of the DB-9 connector.
2. Align the mounting tab located on the front of the KP 12 CLD GPIO expansion unit with the mounting tab slot located on
the rear of the KP 12 CLD unit. See Figure 1.
IMPORTANT: Do not attach the GPIO expansion unit mounting tab to the KP 12 CLD unit. Attaching the unit with this one
(1) screw may cause the chassis to bend or be damaged. Continue to step 2.
FIGURE 1. GPIO Expansion Unit — Mounting Tab Alignment with KP 12 CLD
F.01U.196.235 Rev 04 06/2012
3. Using the screws provided, attach the GPIO Expansion Unit to the rear panel of the KP 12 CLD unit (see Figure 2).
4. Using the screw provided, attach the mounting tab to the mounting tab slot. See Figure 3.
FIGURE 2. GPIO Expansion Unit — Attachment Points
FIGURE 3. Mounting Tab Screw Hole
/