2. RTS
  3. Kp 32 cld gpio
Kp 32 cld gpio

RTS Kp 32 cld gpio User manual

  • Hello! I am an AI chatbot trained to assist you with the RTS Kp 32 cld gpio User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
KP 32 CLD GPIO Option Card
Installation Instructions
To install the GPIO option card in to the KP 32 CLD, do the following:
1. Using a Phillips head screw driver, remove the nine (9) screws securing the blank plate in place on the rear of unit (see Figure 1 for
screw locations).
2. Remove the blank plate.
FIGURE 1. Screw Removal Locations
FIGURE 2. GPIO Connector on the KP 32 CLD board
LIT000440000 Rev A 9/2009
3. Connect the GPIO Option Card cable to the GPIO connector (see Figure 2) within the KP 32 CLD.
IMPORTANT: Connect Pin 1 (red wire) on the furthest left side of the connector as shown in Figure 3. Pin 1 is also designated by the
1 on the KP 32 CLD board, as seen in Figure 2, Detail A.
4. Align the GPIO Option Card with the screw holes on the KP 32 CLD.
5. Replace the screws in the appropriate holes (see Figure 1).
For information about the GPIO option card features, see the KP 32 CLD User Manual (93507858000).
FIGURE 3. GPIO Option Card connected to the KP 32 CLD
FIGURE 4. Replacing the GPIO Option card in the KP 32 CLD
/