SportsArt C572R Owner's manual

TABLE OF CONTENTS

CARDIO ACTIVE ENTERTAINMENT STATION (INTEGRATED TV)

FOR THE C572R RECUMBENT CYCLE

CARDIO ACTIVE ENTERTAINMENT STATION (INTEGRATED TV)

FOR THE C572U UPRIGHT BIKE

CARDIO ACTIVE ENTERTAINMENT STATION (INTEGRATED

ANALOG TV) OPERATING MANUAL

CHAPTER 1:

CHAPTER 2:

CHAPTER 3:

1.1 INSTALLATION MANUAL..................................................................................

1.2 INSTALLATION INSTRUCTIONS.......................................................................

STEP 1 Remove the Front Lower Cover.........................................................

STEP 2 Disconnect Cables and Remove the Pedestal...................................

STEP 3 Remove the Left Pedal and Crank Cover...........................................

STEP 4 Install Cables......................................................................................

STEP 5 Organize Cables.................................................................................

STEP 6 Install the Left Side Cover and Pedal.................................................

STEP 7 Secure the Pedestal...........................................................................

STEP 8 Remove the Cutaway.........................................................................

STEP 9 Install the Integrated TV Module........................................................

STEP 10 Install the Adaptor Box.......................................................................

STEP 11 TV Angle Adjustment..........................................................................

2.1 INSTALLATION MANUAL..................................................................................

2.2 INSTALLATION INSTRUCTIONS.......................................................................

STEP 1 Remove the Pedestal and Front Lower Cover......................................

STEP 2 Disconnect Cables and Remove the Pedestal......................................

STEP 3 Install Cables.........................................................................................

STEP 4 Install the Seat Bottom and Pedals.......................................................

STEP 5 Remove the Cutaway............................................................................

STEP 6 Install the TV Module...........................................................................

STEP 7 Install the Adaptor Box.........................................................................

STEP 8 TV Angle Adjustment............................................................................

3.1 TV Operating Instructions...................................................................................

3.2 CATV Function Settings......................................................................................

1

2

4

6

7

8

9

10

11

12

13

16

17

18

19

21

23

24

25

26

27

30

31

33

34

3.3 OSD Menu and Keys in CATV Mode...................................................................

3.4 How to Perform the Search Function..................................................................

3.4.1 Search Function Illustrations - TV System........................................................

3.4.2 NTSC Cable Illustration.....................................................................................

3.4.3 TV Scan............................................................................................................

3.4.4 TV Channel Search in Progress.......................................................................

3.4.5 iPod Function....................................................................................................

3.5.1 iPod Function Illustrations – iPod System........................................................

3.5.2 iPod Function Illustrations – iPod On...............................................................

3.5.3 iPod Function Illustrations – Source Key..........................................................

3.6.1 OSD Menu, Other Functions - Video................................................................

3.6.2 OSD Menu, Other Functions - Audio................................................................

3.6.3 OSD Menu, Other Functions - System.............................................................

3.6.4 OSD Menu, Other Functions - DTV..................................................................

4.1 Digital TV System Cable Connections.................................................................

4.2 Integrated TV Screen Illustration.........................................................................

4.3 DTV ATSC-USA Digital TV Functions............................................................

4.4 DTV Mode Operation...........................................................................................

4.4.1 DTV Mode.........................................................................................................

4.4.2 ATSC Menu.......................................................................................................

4.4.3 DTV Mode Key Definitions................................................................................

4.5 Introduction to the ATSC Menu............................................................................

4.6 Auto Search Operation.........................................................................................

4.6.1 DTV Menu.........................................................................................................

4.6.2 Scan Window....................................................................................................

4.6.3 Channel Search Completed Window................................................................

4.6.4 Channel Scan...................................................................................................

4.7 DTV DVB-T (European) Digital TV Functions................................................

4.8 The System Setup Process.................................................................................

4.8.1 Country Setting.................................................................................................

4.8.2 Channel Search................................................................................................

4.8.3 Channel Search Block Diagram........................................................................

CHAPTER 4: CARDIO ACTIVE ENTERTAINMENT STATION – INTEGRATED

DIGITAL TV

（）

34

37

38

39

40

41

42

43

45

47

48

50

51

52

54

55

56

60

4.9 Other Notes.........................................................................................................

4.9.1 DVB-T Menu.....................................................................................................

4.9.2 Program Search................................................................................................

4.9.3 Parental Control................................................................................................

4.9.4 System Settings................................................................................................

4.9.5 Games..............................................................................................................

4.9.6 Accessories......................................................................................................

4.9.7 Personal Style..................................................................................................

4.10 Setup Menu Navigation.....................................................................................

4.11 DVB T Frequency Table and Country List..........................................................-

63

64

65

66

67

68

1

Install the CardioActive™ Entertainment Station (integrated TV) onto the SportsArt

C572R cycle as follows.

L

R

CHAPTER 1－CARDIO ACTIVE ENTERTAINMENT STATION

(INTEGRATED TV) FOR THE C572R RECUMBENT BIKE

1.1 INSTALLATION MANUAL

No. Qty

No.

Qty

A1

A2

A3

A4

1

5

1

A6

A7

A8

A9

A10

2

1

Parts in the Main Module Assembly

Integrated TV module

Owner's manual

TV lower power cord

TV adaptor

Power switch

F connector adapter

A5

Coaxial cable splitter

Ground wire

Lower cable

Zip tie

Part Name Part Name

Power cord

1.2 INSTALLATION INSTRUCTIONS

STEP 1 Remove the Front Lower Cover

4

3

No. Name Qty

21

Parts in the Hardware Kit

4

1

2

1

Specification

Notes

Inner hex screw

Spring washer

Serrated washer

Screwdriver bit and handle

L-shaped Allen wrench

M11 open-end wrench

Double open-end wrench

L-shaped Allen wrench

M6*L15

M6

D20*d6.2*t2.0*19t

Straight and Phillips heads

M5

M6

M4

12*15

The CardioActive™ Entertainment Station is an integrated TV module for use on

several SportsArt Fitness products. Please follow instructions below to install this

integrated TV module on the C572R cycle.

Note: For brevity, throughout this manual, the word “screws” is used where screws,

washers, and other hardware may be involved. Also, the words “left” and “right” are

used in reference to the product and its parts. Note that as such, these designations

correspond to the left and right sides of a person in position to work out on the

product. Also note that some parts are marked “L” for left or “R” for right.

5

(a) Remove the front lower cover as indicated by (A) and (B) below.

Remove screws separately from the power terminal plate and the AV terminal

plate.

First, loosen the nut on the . From the front, secure the AV

terminal plate. Then install the power switch (A5) into the power switch bracket.

On the other side, first loosen the nut. Then, inserting it from the front, secure the

cable connector as shown.

(b)

(c) F connector adapter (A5)

(b)

(a)

(c)

A

B

STEP 2 Disconnect Cables and Remove the Pedestal

(

(c)

a) Remove screws from the display cover.

(b) Disconnect cables in three places, A, B, and C. In area D, remove the two cables;

these cables will not be needed.

Remove the caps that cover screw heads on the pedestal. Then remove the

screws from the pedestal.

(d) Lift the pedestal, and disconnect the data cable.

6

(d)

(c)

(b)

(a)

A

B

C

D

STEP 3 Remove the Left Pedal and Crank Cover

(a) Remove the left pedal.

(b) Remove the crank cover.

c) Remove screws from the left side cover.

(d) Rotate the crank 180 degrees until it points upward vertically as shown.

(e) Lift the left side cover off, tilting it to avoid the crank and the product frame.

(

7

(e)

(d)

(c)

(b)

(a)

STEP 4 Install Cables

(a) From the hole in the display cover, thread the TV lower power cable (A3) and

lower cable (A8) into the pedestal. Then thread the cables through the unit, and

out the hole at the left side as shown.

(b) Lift the pedestal. Tuck cables safely into the pedestal and its base, making sure

that cables will not get pinched. Then insert the pedestal into its base, and secure

the pedestal screws.

8

(b)

(a)

STEP 5 Organize Cables

(a) After connecting cable (A3), cable (A8), the power switch, and the

, secure the power switch bracket onto the unit as shown.

(b) Starting at the power switch bracket side, organize cables. Use zip ties (A9) to

secure the cables to the frame as shown.

F connector

adapter (A5)

9

(b)

(a)

STEP 6 Install the Left Side Cover and Pedal

(a) Hold the crank up while slipping the left side cover into place.

(b) Turn the crank 180 degrees, so it hangs downward.

(c) Secure left side cover screws.

(d) Put the crank cover back into place.

(e) Secure the left pedal back into place.

10

(e)

(d)

(c)

(b)

(a)

STEP 7 Secure the Pedestal

(a) Secure the pedestal screws and their caps.

(b) Put the front lower cover into place, following sequence (A), then (B).

11

(b)

(a)

A

B

STEP 8 Remove the Cutaway

Remove the cutaway to allow for installation of the TV module.

(a) Remove the sticker from the top of the fan cover.

(b) Use a pair of wire cutters to remove the cutaway in area A.

12

(b)

(a)

A

STEP 9 Install the Integrated TV Module

Follow steps (a) through (f) to install the TV module.

(a) Before installing the integrated TV module (A1), carefully cut the zip tie off the coil

of cables. From above the cutaway area, align the integrated TV module (A1)

with the guide tube. While sliding the integrated TV module into place, feed the

cables through holes in both sides of the display covers. Two cables go into the

hole in the right side; Other cables go through the hole in the left side.

(b) Put a screw (21) through the end of the ground wire (A7) and secure all screws,

first in area A, then in area B. Note: Place the serrated washer lowest when

securing the ground wire.

13

(b)

(a)

L

R

A

B

(c) Secure the coaxial cable splitter (A6) onto the display lower cover. Then

connect integrated TV module (A1) CATV(1) and DTV(2) cables and the lower

coaxial cable (A3) to the splitter (A6). Then secure the ground wire (A7) from the

center of the wires marked (L2) onto the coaxial cable splitter ground wire

connection.

S

14

(c)

15

(e)

(d)

(f)

B

C

A

b

a

(d) Connect the integrated TV cable (L1) to the similarly marked TV lower power cable

(A3).

(e) Connect the integrated TV module cable (L2) to the board for iPod. Connect cable

(L3) to the display board. (Note: There are two types of boards for iPod. One

supports audio-video functions. The other one only supports audio functions. If you

intend to use video, you must use a board with audio-video functions. To use an

audio-only board for iPod, you need not connect cable (L2). If no board for iPod is

to be used, do not connect cable (L2). Leave it disconnected but secured in the

display area.

(f) After connecting cables, secure the display cover.

Audio-only board for iPod

Audio-video board for iPod

STEP 10 Install the Adaptor Box

Route the adaptor cord under the front of the cycle, insert it into the adaptor (A4), and

insert the main power cord from the adaptor box into the power outlet, and insert it

into the power cord (A9)

16

STEP 11 TV Angle Adjustment

To secure the angle of the TV screen at its recommended position, follow instructions

on the sticker (inside the neck cover). To secure the TV screen angle at a different

position, follow steps (a) through (d) below.

(a) Remove the integrated TV module neck cover.

(b) Remove the screws at the lower left and right sides of the bracket (area B).

Loosen (but do not remove) screws in position (A) until the angle of the TV screen

can be adjusted.

After adjusting the angle of the integrated TV screen, secure screws in area (A).

While aligning screw holes, secure screws from step (b).

(c)

(d)

(b)

(a)

A

C

B

17

Page is loading ...

SportsArt C572R Owner's manual

This manual is also suitable for

SportsArt C572R Owner's manual

Related papers

Other documents