9/17
Product Parts
1 - Top Clamp
(x4 single door),(x6 double door*)
2 - Top Clamp Connector
(x4 single door),(x6 double door*)
3 - Bottom Tension Clamp
(x4 single door),(x6 double door*)
4 - Screws/Nuts
(x8 single door),(x12 double door*)
5. Garage Door Banner Graphic
Garage Door Banners
Display Set-Up
Place Top Clamps (1), evenly spaced, along top of garage door.
Step 2
Raise garage 6” to 12” to allow for easier access to clamps.
Step 4
Feed hook on Bottom Tension Clamp (3) through hole on Graphic (5)
Optional: Cut slit in graphic to allow for garage door handle.
Step 3
Attach the Bottom Tension Clamps (3), evenly spaced, along bottom of the
garage door.
1
4
2
Storage & Care
Store in a cool dry location.
Vinyl: Spot clean with damp cloth.
Optional
3
5
*Amount is doubled for a Split Double Garage Door and varies for custom sizes.
Side View
Graphic
Hook on
Bottom Tension
Clamp
Hole in
Graphic
This part of
Bottom Tension Clamp
moves up and down
under spring tension.
Step 5
Reconnect power and remove blocking. Resume normal operation of
garage door.
Step 1
Unroll Graphic (5) and locate pre-drilled holes along top of the Graphic (5).
Place the Graphic (5) over Top Clamp (1) and feed two Screws (4) through Top
Clamp Connector (2) and hole on Graphic (5) then into nut on the back of the
Top Clamp (1). Repeat for remaining Top Clamps.
WARNING: Disconnect power and block door to prevent
accidental closing. Placing of Graphic and hardware
requires a minimum of 2 people.
Side View
Graphic
Top Clamp
Connector
Front View
Graphic
Top Clamp
Connector
D
o
o
r
Top Clamp
Product Parts (Single)
1 - Top Clamp (x3)
2 - Top Clamp Connector (x3)
3 - Bottom Clamp (x3)
4 - Ball Bungee (x3)
5 - Screws (x6)
6 - Washers (x6)
7 - Graphic
1
3
2
4
5
6
Garage Door
(Street View)
Garage Door
(Street View)
Side View
Graphic
Top Clamp
Connector
Front View
Graphic
Top Clamp
Connector
Side View
Graphic
Ball Bungee
Optional
Side View
Graphic
Hook on
Bottom Tension
Clamp
Hole in
Graphic
Top Clamp
Side View
Front
Side View
Side View
Graphic
Hole in
Graphic
Product Parts (Single)
1 - Top Clamp (x3)
2 - Top Clamp Connector (x3)
3 - Bottom Clamp (x3)
4 - Ball Bungee (x3)
5 - Screws (x6)
6 - Washers (x6)
7 - Graphic
1
3
2
4
5
6
Garage Door
(Street View)
Garage Door
(Street View)
Side View
Graphic
Top Clamp
Connector
Front View
Graphic
Top Clamp
Connector
Side View
Graphic
Ball Bungee
Optional
Side View
Graphic
Hook on
Bottom Tension
Clamp
Hole in
Graphic
Top Clamp
Side View
Front
Side View
Side View
Graphic
Hole in
Graphic
BLOCK BLOCK
/
