Shenzhen Zhong tai dian Digital Co.Ltd Z10 User manual

Type
User manual
1. How to connect
Connect to a bluetooth device
1. The matching mode: press ", "3-6 seconds long boot, prompt and blue lights flash,
enter the bluetooth search pattern.
Open the bluetooth phone and search equipment, found in mobile search list has to
Bluetooth Speaker
search the bluetooth speakers
Device name "FozentoFt10" click on the match.
Back to connect mode: press ", "3-6 seconds long boot, slow flashing blue lights,
this state to back even mode.
If pairing is not successful, please restart your mobile device and your bluetooth
speakers, according to the connected steps to reconnect.
If there is no set on mating 5 minutes automatic shutdown.
2. How to use
Music mode
Short press "play and pause the music.
Short press the "+" key to increase the volume, long press the "+" key for more
than 2 seconds, switch to the next.
Short press "-" to reduce the volume, long press "-" key for more than 2 seconds,
switch to the on a.
In the boot state, long press "" button for 4 seconds to turn it off.
Calling patterns
In the condition of connection, double click "" at the end of the keys to number
redial.
Calls short press the "" answering the telephone," "refuse to answer long by
2 seconds.
3. How to charge
Insert the charging wire speakers charge, speakers fully charged takes about 3 to
5 hours, if you want to use the charger (please make sure the good charger voltage
value of 5 v2a, do not use higher than this voltage charging charging equipment,
in order to avoid the speakers bring damage performance.After charging the red light
bright, full of red light.Does not support power tips, using low power will
automatically power off.
4. Bluetooth speaker parameters
1. The product rated power: 18 w.
2. The speaker unit: 52 mm 4 Ω 2 x10w
3. The distortion degree: 1 KMH acuities were 0.5 , 0.5 W
4. The frequency range: 20 hz - 20 KHZ
5. The battery capacity: 7.4 V 2200 mah
6. Bluetooth work time: more than 6 h
7. Charging ways: micro USB 5 v 2 a
8. The charging time: about 3-5 h
9. Bluetooth version: CSR8635 4.1 modules
10. The transmission frequency: 2.4 GHz to 2.4 GHz
11. The largest bluetooth receiver range: 10 m
12. Bluetooth support agreement: A2DP/AVRCP/HSP/HFP/SPP/HID
13. Whether with microphone: yes
14. Bluetooth support: a hands-free phone
15. The level of noise reduction: AEC/NR
16. The waterproof level: no
17. Sound box size: 232 x83x75mm (grow)
18. Speaker net weight: 690 g
19. Product model: Z10
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Anychanges or modifications not expressly approved by the party responsible for
compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for aClass
B digital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned
to provide reasonable protection against harmful interference in aresidential
installation. This equipment generates, uses and can radiate radiofrequency energy
and, if not installed and used in accordance with theinstructions, may cause harmful
interference to radio communications. However,there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user isencouraged
to try to correct the interference by one or more of the followingmeasures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement
. The device can be used in portable
exposure condition without restriction.
FCC ID:2ANZV-Z10
Warranty card
Warranty period:
The product quality guarantee period for: since acquisition date 7 days return, 15
days replacement, one year warranty.
Free services:
In the product warranty period, any quality caused by the product itself and all
the users with this warranty card and shopping vouchers, please contact with dealers,
to enjoy free maintenance.
The following will not be free maintenance:
A, no warranty card or product maintenance label has been damaged.
Second, to remove the damage.
Third, because of falling into water or caused by the faults and artificial
mechanical damage.
Four, failure or damage is caused due to force majeure.
The user
name
E-mail
Correspond
ence
address
Contact
phone
number
The zip
code
Descriptio
n and
specificat
ions
Product
model
Dealer
signature
The user
signature
Note: (1) this form should be sealed by seller confirm;(2) for the applicable related
products "3 packets" regulation, the warranty card is equivalent to 3 packets of
prooves;(3) maintenance record will be subject to authorization service maintenance
certificate, application service, please safekeeping.
Shenzhen Zhong tai dian Digital Co.Ltd
4 Floor, Electronic Building of Xiange Science Park, Xixiang streets, Bao'an
District, Shenzhen City, China
After-sales service telephone086-755-32925926
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Shenzhen Zhong tai dian Digital Co.Ltd Z10 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI