2. Pro-Elec
  3. PELL0015

Pro-Elec PELL0015 Operating instructions

  • Hello! I've reviewed the user manual for the PRO-ELEC Solar Motion Sensor Light model PELL0015. This document provides instructions on how to install and operate this solar-powered, motion-activated light, including key features such as its automatic shut-off after 12 seconds and IP65 rating. I'm here to answer your questions about its functionality and usage.
  • How high should the light be installed?
    How long does it take to charge the battery?
    How long does the light stay on after motion is detected?
    What kind of batteries does the light use?
2 LED SOLAR MOTION SENSOR LIGHT
PELL0015
Please read these instructions carefully before use and retain for future reference.
• Avoid locations of high temperature or humidity.
• If the light output becomes less bright or ashes, recharge the batteries.
• Always remove the batteries if the light is not to be used for long periods.
• Only use the recommended specication rechargeable batteries.
• It is recommended to install the light at about 2.5M or higher above ground.
• Drill two holes the wall 50mm apart horizontally in the required location with regard to
any concealed wiring or pipework, use wall plugs if
required and screw in two dome head screws leaving
the heads 4mm proud of the surface.
• Set the function switch to ON.
• Locate the keyhole slots in the back of the light unit
over the screw heads and ensure the light is securely
xed.
• Allow up to 7 hours for the solar panel to fully charge
the battery on rst use.
IMPORTANT SAFETY INFORMATION
INSTALLATION
OPERATION
MAINTENANCE
SPECIFICATION
• When turned ON, the motion sensor will turn on the light when movement is detected
only in low light environments.
• After motion ceases to be detected, the light will
extinguish after 12 seconds.
• Clean the unit only with a soft dry cloth. Do not use any chemicals, abrasives or
solvents that could damage the casing or lens.
Man Rev 1.1
Power supply: 1×18650 Li-ion (1400mAh)
Solar Panel: Monocrystal silicon, 1W (5.5V, 180mA)
Time Delay: 12 sec (auto delay function)
Working time: 3hrs continuous light (7hrs charging time)
Material: PC, ABS, PMMA, PE
Light Source: 2pcs SMD3535 LEDs
Output power high/low modes: 200 lumen
Ambient light: <10LUX
Sensor distance: 0-8m
Sensor angle: 120°
Time delay: 12±2 sec (Auto-delay function)
Product weight: 240g
Product size H x W x D: 162×108×75mm
IP rating IP65
8m
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic
Equipment (WEEE). Any WEEE marked products must not be mixed with general household waste,
but kept separate for the treatment, recovery and recycling of the materials used. Contact your local
authority for details of recycling schemes in your area. Made in China.
PO Box 13362 Dublin 2
PR2 9PP
/