ROOMS TO GO 26000492 Assembly Instructions

Hello! I have reviewed the assembly instructions for the Lauren Bar Cart. This document details the steps for assembling the bar cart, including attaching posts, frames, feet, and shelves. I'm ready to answer any questions you might have about the assembly process or the components mentioned in the instructions.
How many adults are recommended for assembly?

What should I do with the packaging after assembly?

What should I do to ensure bolts are tight?

Pre-assembly:

Remove all parts and hardware from box along with any plastic protective packaging.

Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or

hardware.

Important safety instructions:

Please carefully read all instructions before assembling the bar cart.

For your safety and ease, assembly by two or more adults is recommended.

Keep instructions for future use.

Step 3. Attach the feet (F) to the long posts (D) through the mirror shelf frame (E) following the label "Mirror

Frame" on the shelf frame as shown below. Securely tighten each foot (F).

Step 2. Attach each long post (D) to the short posts (B) through the glass shelf frame (C) following the label

"Glass frame" on the shelf frame as shown below. Securely tighten the long posts (D).

Caution: Failure to follow these instructions may cause the bolts to misalign during assembly.

ADDITIONAL NOTE ABOUT SAFETY: BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE. THEY SHOULD BE

PERIODICALLY INSPECTED AND RE-TIGHTENED TO PREVENT DAMAGE OR INJURY. ALWAYS CHECK TO BE SURE THAT ALL

HARDWARE IS KEPT TIGHTENED.

Step 4.

1) Turn the assembled bar cart to an upright position.

2) Place the clear plastic pad (b) on each frame (A,C,E) as shown below.

3) Gently lay the glasses (G) on the top frame (A) and glass shelf frame (C), and lay bottom mirror (H) on mirror

shelf frame (E) as shown below. Assembly is complete.