CURT 56332 Installation guide

Brand: CURT

Model: 56332

Type: Installation guide

CURT 56332 is a custom wiring harness designed to connect your vehicle's electrical system to a trailer. It is compatible with Hyundai Santa Fe, Veracruz, Kia Sedona, and Sorento models. The harness features a 4-flat connector that plugs into the vehicle's taillight wiring harness, and a 10 AMP fuse to protect the electrical system. The black converter box should be mounted in a protected area, out of the path of spray and debris from the rear wheels and road. Once installed, the harness will allow you to power your trailer's lights, including turn signals, brake lights, and running lights.

INSTALLATION INSTRUCTIONS

CUSTOM WIRING HARNESS

WIRING LOCATION GUIDEAPPLICATIONS

NOTICE

WARNING

TOOLS NEEDED

Signal Circuits - 3.0 amps per side

Tail / Running Circuits - 6.0 amps total

Check vehicle owner's manual or contact

the vehicle manufacturer for more information.

Flat blade screwdriver

Side cutter

The battery connection must be fuse protected, 10 amp max.

Exceeding the product rating can cause loss of warranty,

overheating and potential fire. Do not exceed product rating

or tow vehicle lamp load rating, whichever is lower.

Make Model

Hyundai Santa Fe

Hyundai Veracruz

Kia Sedona

Kia Sorento (with factory tow package)

Kia Sorento (excl. EX and Limited w/ 2.0L 4Cyl)

WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER

SUVS, MINI & FULL-SIZED VANS

(

)

Representative vehicle shown below

S5 - Behind driver side rear bumper

S7 - Behind passenger side rear bumper

S5 S7

All steps must be followed to ensure the wiring harness

will function properly. Once installed, test for proper function

by using a test light or connecting a properly wired trailer.

PAGE 1 • 56332-INS-RA

A B C

D E

INSTALLATION

SAFETY INSTRUCTIONS

Step 1

Locate the vehicle taillight wiring harness connector near the

rear tire on the passenger side, along the frame. The connector

will be similar to the one on the custom wiring harness.

Step 2

Remove the protective cap and insert the custom wiring

harness into the vehicle connector (A,B). Make sure the

connector is fully inserted with locking tabs in place (C).

With factory tow package Without factory tow package

Step 1

Locate the vehicle taillight wiring connector behind the rear tire

of the driver side, on the outside frame rail. The connector will

be similar to the one on the custom wiring harness.

Step 2

Remove the protective cap and insert the custom wiring

harness into the vehicle connector. Make sure the connectors

are fully inserted with locking tabs in place (D).

Step 3

Route the 4-flat to the center of the vehicle by going over the

exhaust along the bumper. Avoid any areas that may cut, pinch or

melt the wire. Secure any loose wires with the provided cable ties.

Step 4

Locate a flat clean surface that is out of the path of spray

and debris from the rear wheels and road. Adhere the black

converter box using the provided double-sided tape. Secure

any loose wires with the provided cable ties (E).

WARNING: Failure to mount the box

in a protected area can cause loss of warranty,

product failure, overheating and potential fire.

Step 5

To complete the installation, insert the provided

10 AMP fuse into the in-line fuse holder.

Veracruz InstallationSanta Fe & Sorento installation

56332-INS-RA • PAGE 2

CURT 56332 Installation guide

CURT 56332 Installation guide

CURT 56332 Installation guide

Related papers

Other documents