INSTALLATION INSTRUCTIONS
CUSTOM WIRING
CONNECTOR
WIRING LOCATION GUIDEAPPLICATIONS
NOTICE
WARNING
TOOLS NEEDED
Signal Circuits - 3.0 amps per side
Tail / Running Circuits - 6.0 amps total
Check vehicle owner's manual or contact
the vehicle manufacturer for more information.
Phillips screwdriver
Panel trim removal tool
The battery connection must be fuse-protected, 10-amp max.
Exceeding the product rating can cause loss of warranty,
overheating and potential fire. Do not exceed product rating
or tow vehicle lamp load rating, whichever is lower.
Make Model
Jeep Grand Cherokee
WARNING: DO NOT EXCEED PRODUCT RATING OR TOW VEHICLE LAMP LOAD RATING, WHICHEVER IS LOWER
SUVS, MINI & FULL-SIZED VANS
(
S
)
Representative vehicle shown below
S3 - Behind driver side rear access panel
S3
All steps must be followed to ensure the wiring connector will
function properly. Once installed, test for proper function by
using a test light or connecting a properly wired trailer.
PAGE 1 • 55369-INS-RC
A B
H
C
D
G I
E F
Step 1
Locate vehicle battery on the driver side under the
hood and disconnect the negative battery terminal.
Step 2
Open the vehicle tailgate. Remove the cargo cover and net (A).
Step 3
Remove the two screws securing the rear threshold (B,C).
Step 4
Remove the screw on the driver side trim panel and pull back
the panel to gain access to the green vehicle harness (D,E,F).
Step 5
Insert the green custom wiring connector housing into the green
vehicle harness housing. Make sure the connectors are fully
inserted with locking tabs in place by pushing the red lock tab
to the side (G).
Step 6
Locate a flat spot inside the vehicle, near the taillight. Adhere the
black converter box using the provided double-sided tape (H).
Insert the 10-amp fuse provided into the red inline fuse holder.
Step 7
When in use, route the 4-flat to the center of the vehicle. When
not in use, roll up and store in a convenient, out of the way
location. Secure any loose wires with the provided cable ties.
Step 8
Reinstall all items removed during install and reconnect
negative battery terminal. Install the provided 4-flat dust
cover to help prevent corrosion.
INSTALLATION
/
SAFETY INSTRUCTIONS
55369-INS-RC • PAGE 2
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Jeep WRANGLER 2017 User manual
-
Chevrolet 2008 Tahoe Owner's manual
-
-
-
GMC 1995 Safari Passenger Owner's manual
-
Dodge 2007 ND Dakota User manual
-
RAM 2021 1500 Classic Owner's manual
-
-
Chevrolet TAHOE POLICE - 2011 User manual
-