Leviton RELAY-L30 Installation guide

Type
Installation guide

This manual is also suitable for

Installation Guide
Z-MAX™ Barrier
rac00-vbr
For segregating parts of the cabinets into groups of
(8) relays for voltage or emergency purposes
November 2004
DI-007-rac00-00a
Rev. A
Check www
.leviton.com for the latest updates to this information
Leviton NSI Division Headquarters
20497 SW Teton Avenue, Tualatin, OR 97062
Customer Service Telephone: 800.736.6682
Customer Service Fax: 503.404.5594
Technical Services: 800.959.6004
Leviton Manufacturing Company, Incorporated
59-25 Little Neck Parkway, Little Neck, NY 11362-2591
Visit Leviton’s websites at http://www.leviton.com
& http://www.nsicorp.com
Copyright© 2004 Leviton Manufacturing Company, Inc. All Rights Reserved
Specifications and pricing subject to change at any time.
Warranty Information
Warranty
LEVITON LIGHTING CONTROLS DIVISION of Leviton manufacturing Co. Inc. warrants its Dimmer Systems
and Controls to be free of material and workmanship defects for a period of two years after system accept-
ance or 26 months after shipment, whichever comes first. This Warranty is limited to repair or replacement
of defective equipment returned Freight Pre-Paid to Leviton Lighting Controls Division at 20497 Teton Ave.,
Tualatin, Oregon 97062, USA. User shall call 1-800-959-6004 and request a return authorization number
to mark on the outside of the returning carton, to assure that the returned material will be properly received
at Leviton. All equipment shipped back to Leviton must be carefully and properly packed to avoid shipping
damage. Replacements or repaired equipment will be returned to sender freight prepaid, F.O.B. factory.
Leviton is not responsible for removing or replacing equipment on the job site, and will not honor charges
for such work. Leviton will not be responsible for any loss of use time or subsequent damages should any
of the equipment fail during the warranty period, but agrees only to repair or replace defective equipment
returned to its plant in Tualatin, Oregon. This warranty is void on any product that has been improperly
installed, overloaded, short circuited, abused, or altered in any manner. Neither the seller nor Leviton shall
be liable for any injury, loss or damage, direct or consequential arising out of the use of or inability to use
the equipment. This Warranty does not cover lamps, ballasts, and other equipment which is supplied or
warranted directly to the user by their manufacturer. Leviton makes no warranty as to the Fitness for
Purpose or other implied Warranties.
Installation Instructions
Barrier
Z-MAX Relay Panel
1. Slip metal stiffener off of the edge of the plastic barrier.
2. Locate the place the barrier is to be installed. The barrier
installs between the relay bus boards containing the
groups of 8 relays. Note that there are double dimples in
the sides and back of the cabinet.
3. Note that the barrier completely closes off the horizontal
cross-section of the cabinet. Relocate any wiring that might
be in the way of the barrier.
4. Orientate the barrier. The cabinet is not symmetrical. The
opening must be centered on the relay bus board. Also the
door requires a notch on the right side to clear its flange.
5. Hold barrier parallel with the front of the cabinet and insert
one end against the cabinet wall. Flex the barrier and insert
the other end.
6. Roll the barrier into a vertical position between the relay
bus boards. On the 48-relay cabinet make sure that the
power supply wires on the right side are routed through
the opening and not pinched.
7. Pop the barrier into all the double-dimple retainers.
8. Slip the metal stiffener back onto the edge of the barrier.
Make sure the edge of the stiffener is not covering the
notch on the right side to accept the door flange.
DI-007-rac00-00a
Rev. A
Zero or more voltage barriers may be installed in the Z-MAX 24
or 48 relay cabinets dividing the relays into groups of 8.
The Z-MAX 24 relay cabinet is shown with (2) voltage barriers
installed. Consult factory for additional information
INSTALLED VOLTAGE
BARRIER (TYPICAL)
WEB VERSION
  • Page 1 1

Leviton RELAY-L30 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI