v8 t.a.n.k 20W
user guide
main features
Thank you for choosing the V8 T.A.N.K 20W guitar amplier. Before using the unit, please read this user guide entirely for
proper and safe operation. We wish you many happy moments with this unique product. - The V8 Team.
• Simple, rechargeable and durable guitar amplier with large 10” speaker and 10/20W output.
• With included AC adapter the unit’s lead accumulator can be recharged for over 8 hours of continuous playing time (this
may vary according to playing conditions). Note that the unit can be recharged when On or Off and even when playing.
• Dual input with separate volume controls for connecting guitar, music player or microphone.
• External speaker output for full 20W operation with matched T.A.N.K speaker or your favorite 8 ohm cabinet.
• 12V input/output for recharging and extra appliances by using the standard car adapter.
control panel
H
O
T
C
O
O
L
H
I
L
O
X
T
S
P
15v
dc
T
A
N
K
ON
OFF
HOT Input
To connect guitar or mic.
COOL Input
To connect guitar or music player.
HOT Volume Knob
To adjust the output volume.
COOL Volume Knob
To adjust the output volume.
HI Tone Knob
To adjust the brightness.
LO Tone Knob
To adjust the bass.
XTSP Output
To connect the external T.A.N.K speaker.
DC Input
To connect the AC adapter.
ON/OFF Switch
To turn the unit on and off.
Various 12V accessories can be connected, like powering effect pedals (with optional 12V to 9V
adapter), cell phone chargers, led lights, etc. However using external appliances will shorten the
available playing time. Note that the combined power consumption should not exceed 25W.
The standard (car) connector is placed on top of the unit with fuse for easy access.
12V DC Input/Output
When using music players it is preferable
to ne tune volume in the source.
Centre pin is negative.
Note: To extend the accumulator life you
should always remove the AC adapter
after recharge.
Use 8 ohm speaker.
Amplisonic Ltd
Pohjankyröntie 27
61500 Isokyrö
Finland
+358 (44) 214 1848
shop@amplisonic.
www.amplisonic.
www.v8amps.com
The information on the products is correct at the time of printing.
Please check our website, www.v8amps.com for any updates not
contained in this publication.
All rights reserved.
The manufacturer reserves the right to vary specications, features
and appearance including with or without notice.
© AMPLISONIC LTD 2012
HANDCRAFTED IN FINLAND
specifications
• OutputRating:
10W @ 8 ohm
20W @ 4 ohm (with external cabinet)
• Speaker:
1 x 10” 8 ohm, Celestion Tube 10
• Operationtime:
~ 8 hours
• Rechargetime:
~< 16 hours
• Connectors:
HOT Input Jack: XLR/1/4” combo
COOL Input Jack: 1/4” phone
XTSP Output Jack: 1/4” phone
AC Adapter Input Jack
12V DC (Car) Adapter
• Controls:
HOT Volume: Knob
COOL Volume: Knob
HI Tone: Knob
LO Tone: Knob
ON/OFF: Switch
• Sensitivity:(at full power)
HOT Channel: 60mV
COOL Channel: 300mV
• PowerSupply:
DC 15V: AC Adapter 1.2A (centre pin negative)
12V/7Ah Lead-acid Accumulator
• IdleCurrent:
~ 100mA
• InternalFuse:
2A
• DC(Car)AdapterFuse:
2.5A
• Dimensions:
38 (W) x 18 (D) x 48 (H) cm
15 (W) x 7 (D) x 19 (H) inch
• Weight:
8 kg
18 lbs
• Accessories:
AC Adapter, 3.5mm to 6.3mm jack adapter,
User Guide.
WARNING
MAINTENANCE
• Do not use or leave this unit in extreme temperatures or in moist or in rain.
• Do not open or modify the unit or its AC adapter in any way or attempt to repair the unit, or replace parts within it except
when instructed in the user guide to do so.
The unit is powered by standard lead-acid accumulator that in normal conditions has lifespan of 5 years. This gure will vary
depending on the actual conditions of use. Note: To extend the accumulator life you should always remove the AC adapter
after recharge.
The power supply can be replaced by removing the control panel and replacing the accumulator inside. Always turn off the
power and disconnect any other devices before opening the unit cover to prevent damage to speakers and other devices.
This product complies with the requirements of European Directive 89/336/EEC.
All electrical and electronic products should be disposed of separately from the municipal waste.
WARRANTY
The standard warranty for the unit and parts (excluding accumulator) is 1 year to original purchaser. This does not apply if
the unit has been modied or serviced at a non-authorized service center or personnel or damaged by shipping carrier.
/
