Everbilt 41802 Installation guide

  • I have reviewed the provided installation instructions for the EVERBILT Shower Stem 1006960801. This document details the steps for installing the shower stem, including instructions for both shower with flange or shower with sleeve and flange configurations, and outlines the tools needed for the job. I'm ready to assist with any questions you have about the installation process.
  • What tools are needed for the installation?
    What is the first step in the installation process?
    What should be used to protect the finish when removing the flange?
Installation Instructions:
1. Turn off water supply. Release pressure.
2. Remove handle button and handle screw. (Use handle puller if you have trouble removing your handle.)
3. Remove the flange. (Use masking tape to protect the finish.)
4. Remove the old stem using the socket wrench. (NOTE: If replacing the stem only, skip to step 6.)
5. Using a seat wrench, remove the old faucet seat and replace with the seat included.
6. Make sure cap stem gasket is in place, and thread new stem into faucet. Tighten with socket wrench. (Do not over tighten.)
7. Reinstall the flange.
8. Replace handle and button.
9. Turn on water and check for leaks.
SHOWER STEM
INSTALLATION INSTRUCTIONS 1006960801
Tools Required:
Screwdriver
Adjustable Wrench
Seat Wrench
Socket Wrench
Optional:
Handle Puller
Shower with Flange:
ButtonScrew
HandleFlange
Nipple
Stem
Bibb
Seat
Cap
Gasket
Shower with Sleeve and Flange:
Bibb
Seat
Cap
Gasket ButtonScrew
Handle
Sleeve
Flange
Stem
/