elero Combio-868 HE Operating instructions

Combio-868 HE – Operating instructions

(28 594.0001)

Important safety instructions!

Observe the following instructions.

Riskofinjuryduetoelectrocution.

Connectionstothe230Vmainsmustbemadeby

authorisedspecialistpersonnel.

•heregulationsofthelocalenergysupply

companyaswellastheregulationsforwetand

damproomsaccordingtoVDE0100mustbe

followedwhenmakingtheconnections.

•Followtherelevantcountry-specificregulations.

•Whenworkingonthesystem(e.g.servicing),

separateitfromthemainssupply.

•Keepchildrenawayfromthecontrolunits.

•Thecontrolunitmustbeinstalledsothatitisnot

exposedtorain.

•Checkthesystemregularlyforwearordamage.

Warning! Note!

• Pleasenotethatradiosystemsmustnotbe

operatedinareaswithanincreasedriskof

interference(e.g.hospitals,airports).

• Theremotecontrolisonlyapprovedfordevices

andsystemsforwhichanymalfunctionofthe

hand-heldtransmitterorreceiverwouldnotresult

inariskforpersons,animalsorproperty,orif

suchariskiscoveredbyothersafetydevices.

• Theoperatorhasnoprotectionwhatsoeverfrom

interferencesbyotherradioemittersandlocal

terminals(e.g.alsofromradioinstallations),that

arenormallyusedonthesamefrequencyrange.

100,5

56.5

105

102

Operating instructions

(translation)

elero GmbH

Antriebstechnik

LinsenhoferStraße59–63

D-72660Beuren

Telefon(0 70 25)13-01

Telefax (0 70 25)13-212

[email protected]

www.elero.com

181104601/0610GB

Wereservetherighttomaketechnicalchanges

Explanation of buttons

Heatingsystem

alternatesbetween

100%and50%

outputfor2minutes.

TheCombio-868HEisnowreadytoprogramfor5minutes.

Thetransmitterisprogrammed.

Pressthe

▲button

immediately

when100%

heatoutput

appears.

Pressthe

▼button

immediately

when50%

heatoutput

appears.

LR03 (AAA)

Lerntaste P

Auto

VarioTec

Reset

Pos Pos

Auto

VarioTec

Reset

Pos Pos

Auto

elero

ProgrammingbuttonP

▲-button(switchon)

STOPbutton(switchoff)

▼-button(switchon)

Initial operation

2. Switch off/on mains.

Heatinggoesoff

forashorttime

Heizunggeht

aus

General information

TheCombio-868HEradioreceiverenablesyoutoturnheating

systemsofupto2kWoutputonandoffbyremotecontrol.

Itisalsopossibletoswitchtheheatingsystemdownto66%ofits

output.

Warning!

TheCombio-868HEisonlysuitableforuse

withheatingsystemswithanominalpowerofmax.

2kW

Do not connect other consumers to the device!

Read the operating instructions of the heating

system.

Warning!

Device becomes hot in use!

Risk of burning!

•EnsurethattheCombio-868HEissufficiently

well-ventilated.

•Donotuseanyhighlyinflammableorinflammable

materialsneartotheCombio-868HE.

Optimal use of the radio signal

• Donotbendtheantenna.

• Donotshortenorextendtheantenna.

• Ifreceptionispoor,adjusttheantenna.

• Installtheantennasothatitisasexposedaspossible.

• Antennaisnottorestonmetal.

• Usinganumberofreceiversmaycauseinterference.

Note: Radiosystems,whichoperateonthesamefrequency,can

leadtoreceptionofinterferences.

 Pleasenote,thattherangeoftheradiosignalislimitedby

thegovernmentandthebuiltenvironment.

STAS3

1=N(blue)

2=L

3=L(bridgedwith2)

STAK3

1=N(blue)

2=LI(black)

3=free(brown)

PE(green/yellow)

Feed cable

Consumer

Caution!

DonotconnectLtoLI.

Udifferentpotentials

Caution!

DonotconnectLtoL

differentpotentials

Note: Ifseveralreceiversareconnectedtothesamefeedline,

thenallaresimultaneouslyreadytoprogram.

 Theheatingsystembeginstobrieflylightup“randomly”.

 Thelongeryouwaitwiththeprogrammingthegreater

willbetheoffset.

 Individualchannels/transmitterscannowbeassignedto

therespectivereceiver.

 Youcanstoptheflashingifyoubrieflypushthe

STOPbuttonofatransmitterwhichhasalreadybeen

programmed.

 Thechannelassignment/changecannowbemade

withoutyouhavingtodisconnecttheindividual

receivers.

Switching on the heating system:

Precondition: Thetransmitterisprogrammed.

PresstheUPorDOWNbutton.

Switching off the heating system:

PresstheSTOPbutton.

Note: TheCombio-868HEswitchesofftheheatingtowhichitis

connectedautomaticallyafter12hours.

Switching on the intermediate stag

Precondition: Thetransmitterisprogrammed.

1.Pressthe▼buttonorthe▲buttontwiceinrapidsuccession.

2.Theheatingsystemoperatesat66%capacity.

Deleting individual transmitters

1.Presssimultaneously:

 •ProgrammingbuttonP

 •STOPbuttoni

2.HolddownthisbuttoncombinationuntiltheLEDgoesout

briefly.

Deleting all transmitters

1.Presssimultaneously:

 •ProgrammingbuttonP

 •▲-button

 •STOP-Taste

 •▼-button

2.HolddownthiscombinationofbuttonsuntiltheLEDflashes

3xandthengoesout.

Programmingpossibleformax.16transmitters.

Toprogramfurthertransmitters,proceedasfollows:

elero

Heating

systemalter-

natesbet-

ween100%

and50%

outputfor

2minutes.

Thetransmitterisprogrammed.

Pressthe

▲button

immediately

when100%

heatoutput

appears.

Pressthe

▼button

immediately

when50%

heatoutput

appears.

Auto

VarioTec

Reset

Pos Pos

Auto

VarioTec

Reset

Pos Pos

Auto

VarioTec

Reset

Pos Pos

Auto

Programming additional transmitters

Programmedtransmitter

min.3sec.

LR03 (AAA)

Lerntaste P

Auto

▲-button(switchon)

STOPbutton(switchoff)

▼-button(switchon)

Back of device

LR03 (AAA)

Lerntaste P

Heatinggoesoff

forashorttime

Heatinggoesoff

ontheprogrammedtransmitter

ProgrammingbuttonP

Operation with a ProLine timer

IftheCombio-868HEisoperatedwithaProLineclocktimer,no

operatingtimes(Displayshows––:––)maybeentered.

Thisappliesforthemenuitems:

–“Intermediateposition”

–“Ventilation/Tilting”

Inaddition,thedevicemustbesetto“Prog1EndPosition”or

“Prog2EndPosition”(ifactive).

Technical data

Mains voltage 230V

Frequency 50Hz

Max. connected power 2000W

Degree of protection IP50

Permitted

ambient temperature –20°Cto+30°C

Cables Mainscable530mm(STAS3)

 Cabletoheating275mm(STAK3)

Back-up fuse  10Atimedelay

Max. number of transmitters 16

Important: Notetheoutputoftheheatingsystem!

Notes on troubleshooting

Fault Cause Remedy

 Noradioreception 1.Transmitteris Programthe

  notprogrammed. ransmitter.

  2.Nopower Switchon

   supply. powersupply.

 Badradioreception Change Changeposition

  unfavourable ofreceiver

  positionof oraerial.

  receiver.

 Heatingdoesnot 1.Heatingsystem 1.Check

 heatup  wrongly  connection.

   connected.

  2.Heatingelement 2.Replaceheating

   isdefective.  element.

Available accessories (notincludedinthescopeofdelivery)

• Cable3x1.52Cablelength:6.5m

 withSTAK3andearthedplug.

• STAS3forconnectionoftheheatingsystemtothe

Combio-868HE.

elero Combio-868 HE Operating instructions

Related papers

Other documents