MyBinding Best-Rite 505-8 Assembly Instruction

Brand: MyBinding

Model: Best-Rite 505-8

Type: Assembly Instruction

Best-Rite 8' Best-Bite

Tackless Paper Holder - 4pk

Instruction Manual

Part List

Hardware List

Should you require assistance

during assembly, please call our

Customer Service Department

Monday- Friday 8 a.m.-5 p.m. CST

1-800-749-2258

P1 Best-Bite 1 EA

A Mounting Bracket 6 EA

B Screw 6 EA

C Screw

Anchor-Concrete 6 EA

D Magnet Strip None

E Double Sided

Tape 6 EA

BESTBITE-12-NL

P-1

Peel off protection paper

from one side of Double

Sided Tapes (E).

See Illustration #4

Protection

Paper

P-1

1. 2.

Illustration # 4

Illustration # 5

Illustration # 6

Wipe off the surface where

Best-Bite(P1) will be installed.

Press the unit with the exposed

Double Sided Tape against the

wall surface. See Illustration #6.

Protection

Paper

Option Two

P-2

P-1

3. Snap the Best-Bite (P1)

over the Plastic Bracket (A)

as shown in Illustration #3.

Illustration # 3

There are Two Ways to Install Your New Best-Bite.

Best Bite Location

Install two Screw Anchors(C)

and two Mounting Brackets(A)

using two Screws (B).

Option One

Locate and

Drill 2 pilot holes

using 1/4” drill bit.

Length

P-1

Wipe off the back of Best-Bite (P-1)

to remove all particles. Place the

tape’s

peeled sides on to the back of the

unit

in even spaces, and remove the other

protection paper from the Double

Sided

Tapes (E). See Illustration #5.

WWW.MYBINDING.COM

MyBinding Best-Rite 505-8 Assembly Instruction

MyBinding Best-Rite 505-8 Assembly Instruction

MyBinding Best-Rite 505-8 Assembly Instruction

Related papers

Other documents