H-1617
RADIO RECEIVER
Instruction manual
2
Controls
Front panel Remote controller (RC)
1. STANDBY button
2. TIMER button
3. SLEEP button
4. SNOOZE button
5. FOLDER- button
6. MONO/ST button
7. REPEAT button
8. VOL+ button
9. PLAY/PAUSE button
10. EQ button
11. CLOCK button
12. MUTE button
13. PRE-UP button
14. PRE-DN button
15. INTRO+ button
16. FOLDER+ button
17. MEMORY button
1. FUNCTION button 18. RAND button
2. BAND button 19. BAND/TAG button
3. PLAY/PAUSE button 20. NEXT button
4. LCD Display 21. PREV button
5. Standby indicator 22. VOL- button
6. Remote sensor 23. FUNCTION button
7. FOLDER button
8. PREV/TUNE DN button
9. NEXT/TUNE UP button
10. Left speaker
11. USB port
12. VOLUME/POWER knob
13. SD/MMC slot
14. Right speaker
3
Back panel
1. FM antenna
2. Ventilation hole
3. AUX input
4. POWER switch
5. Power cord
4
Turning On/Off
Plug the power cord into a wall outlet.
Locate the POWER switch on the rear panel and set it to the ON position.
Press the VOLUME/POWER knob on the front panel to turn the unit on.
RC Battery Installation
Insert 2 x “AAA” size batteries into the battery compartment. Be sure that the batteries are inserted correctly to avoid damage to the RC. Always remove the
batteries when the RC will not be used for a long period of time, as this will cause leakage to the batteries and subsequently damage to your set.
Notes: Use batteries of the same type. Never use different types of batteries together. If the distance required between the RC and the unit decreases, the
batteries are exhausted. In this case replace the batteries with new one.
Radio operation
Automatic tuning
Press the FUNCTION button to select “TUNER” mode.
Press the BAND/TAG button to select AM or FM.
Press the NEXT or PREV button to start automatic tuning process.
Manual tuning
It is intended for selecting stations, which cannot be tuned automatically (manual selection). To tune a channel manually:
Press the FUNCTION button to select “TUNER” mode.
Press the BAND/TAG button to select AM or FM.
Shortly press the NEXT or PREV button (0.5 second or less), the frequency changes by a fixed step: FM: 0.05 MHz steps/AM: 9 kHz steps.
Memory preset
After performing automating tuning, press the MEMORY button to start the preset process.
Display will show the memory sequence number and a flashing “1”.
Press the PRE-UP or PRE-DN button or the MEMORY button of the front panel to determine the preset station number.
Press again the MEMORY button to preset your desired station.
Once all the stations were preset, press the PRE-UP or PRE-DN button to listen to your desired station.
Mono/Stereo
Press the MONO/ST. button to achieve the best frequency.
5
USB/SD/MMC operations
Playback
Put USB or SD/MMC card to the corresponding port/slot.
Press the FUNCTION button to select “USB/SD” mode.
The LCD will display “READING” while the stereo scans for MP3 from the USB/SD/MMC device. The LCD will display the
total number of the folders of MP3 files and start the playback automatically.
Press the button again to stop playing USB/SD operation temporarily.
Press the button again to resume playback.
Press NEXT button to go to the next track.
When the playback finish, the playback will start to play again from the beginning.
Repeat
Press the REPEAT button during playing USB/SD/MMC card, each press switches the repeat function as follows: REPEAT ALL => REPEAT
FOLDER => NORMAL PLAYBACK
Other functions
EQ
Press the EQ button on RC, each press switch the EQ function as follows: CLASSIC => ROCK => POP => JAZZ => BASS – ON => FLAT (normal).
ID3 Tag (For MP3 only)
Press once BAND/TAG button, ID3 text will show on display.
Press the button again to terminate ID3 mode.
Notes: Due to various solutions, ID3 text function may not be played.
Intro
Press the INTRO button during playback to play each song for 10 seconds.
Press the INTRO button again to resume normal playback.
Mute
Press the MUTE button to remove the sound during playback.
Press the MUTE button again to resume the sound.
6
Random
Press the RANDOM button on RC during playback, the unit will select and play a track randomly.
Press the button again to terminate random mode.
Sleep
Press the SLEEP button on RC, display will show “SLEEP 90”. That means, after 90 minutes the unit will automatically turn to standby mode.
Press the SLEEP button again to select the automatically turn off time, from 90, 80, 70, 60, 50, 40, 30, 20, 10 minutes.
Press the SLEEP button to “SLEEP 00” to cancel sleep function.
Line in (AUX in)
Select AUX mode to listen to external audio devices connected through the 3.5 mm Auxiliary Stereo Line-In jack. Press FUNCTION button to select AUX
mode.
Use a 3.5 mm Male-to-Male Stereo cable to connect any external audio device with a 3.5 mm Headphone or Ling-Out jack to the AUX IN jack on the
rear panel of the stereo.
Start playback on the external audio device. Adjust the volume on the audio device (do not set the volume too high to avoid distortion). You may also
adjust the volume on the unit.
Clock Setting
1. Press the STANDBY button to switch unit to standby mode.
2. Press the CLOCK button twice to entry clock set mode. The display will show “24H” and flashing.
3. Adjust time format (12H/24H) by pressing the PREV or NEXT button.
4. Press the CLOCK button to confirm time format; display will show “AM” or “PM” if 12H format is set.
5. Adjust hour by pressing the PREV or NEXT button, press the CLOCK button to confirm.
6. Adjust minute by pressing the PREV or NEXT button, press the CLOCK button to confirm.
Notes: Because clock setting is at standby mode, the display is dim.
Timer setting
Timer setting should be preformed after clock setting is completed.
1. Press the STANDBY button to switch unit at standby mode.
2. Press the CLOCK button on RC to entry timer set mode.
3. The display will show “TIMER ON”, press the CLOCK button to entry “TIMER ON” setting.
4. Adjust hour by pressing the PREV or NEXT button, press the CLOCK button to confirm.
5. Adjust minute by pressing the PREV or NEXT button, press the CLOCK button to confirm.
6. The display will show “TIMER OFF”; press the CLOCK button to entry “TIMER OFF” setting.
7. Adjust hour by pressing the PREV or NEXT button, press the CLOCK button to confirm.
7
8. Adjust minute by pressing the PREV or NEXT button, press the CLOCK button to confirm.
9. Press the “TIMER” button on RC to activate timer on / off function.
10. Press the “TIMER” button again on RC to terminate timer setting.
Snooze
When the timer is triggered. You may press the SNOOZE button on the RC to delay the alarm for another 5 minutes.
Maintenance and care
When the temperature is under -10C in winter, it will cause the leakage of LCD, in general, please avoid using the radio under low temperature.
Electronic products of this kind should never be subjected to moisture or extreme temperatures.
If necessary, clean the unit with a piece of cloth dampened with water only (be sure the batteries is not inserted to the battery compartment).
Specification
Radio frequency range FM: 88 – 108 MHz
AM: 540 – 1600 KHz
RMS 3.5 W
Power supply 220 V, 50 Hz
Net/Gross weight 2.5 kg/3 kg
Unit dimension (L x W x H) 131 x 270 x 130 mm
Gift box dimension (L x W x H) 212 316 x 180 mm
Specifications are subject to change without notice. Mass and dimension are approximate.
8
()
1. STANDBY
2. TIMER
3. SLEEP
4. SNOOZE
5. FOLDER-
6. MONO/ST
7. REPEAT
8. VOL+
9. PLAY/PAUSE
10. EQ
11. CLOCK
12. MUTE
13. PRE-UP
14. PRE-DN
15. INTRO+
16. FOLDER+
17. MEMORY
1. FUNCTION 18. RAND
2. BAND 19. BAND/TAG
3. PLAY/PAUSE 20. NEXT
4. 21. PREV
5. 22. VOL-
6. 23. FUNCTION
7. FOLDER
8. PREV/TUNE DN
9. NEXT/TUNE UP
10.
11. USB
12. VOLUME/POWER
13. SD/MMC
14.
9
1. FM
2.
3. AUX
4. POWER
5.
10
.
POWER ON ().
VOLUME/POWER , .
2 «AAA» . .
, .
:. .
, , . .
FUNCTION «TUNER».
BAND/TAG, AM FM.
NEXT PREV, .
, . :
FUNCTION, «TUNER».
BAND/TAG AM FM.
NEXT PREV (0,5 ); : FM: 0.05 /AM: 9 .
MEMORY, .
.
PRE-UP PRE-DN MEMORY , .
MEMORY.
, , PRE-UP PRE-DN, .
MONO/ST. .
11
USB/SD/MMC
USB SD/MMC .
FUNCTION «USB/SD».
«READING» MP3 USB/SD/MMC.
; .
.
PLAY/PAUSE.
NEXT.
.
REPEAT USB/SD/MMC ;
: REPEAT ALL () => REPEAT FOLDER () => NORMAL PLAYBACK
).
EQ ; : CLASSIC => ROCK => POP =>
JAZZ => BASS – ON => FLAT (normal).
ID3 ( MP3)
BAND/TAG, ID3 .
ID3 .
: ID3 .
«Intro»
INTRO ; 10 .
INTRO .
MUTE .
MUTE.
12
RANDOM ; .
.
SLEEP ; «SLEEP 90». , 90
().
SLEEP, ; 90, 80, 70, 60, 50, 40, 30, 20 10
.
SLEEP «SLEEP 00»; .
(AUX in)
FUNCTION AUX ,
3,5 .
3,5 AUX IN, .
(
). .
1. STANDBY.
2. CLOCK, . «24H».
3. (12H/24H) PREV NEXT.
4. CLOCK; 12H, «AM» «PM».
5. PREV NEXT, CLOCK.
6. PREV NEXT, CLOCK.
:, .
.
1. STANDBY.
2. CLOCK .
3. «TIMER ON»; CLOCK, «TIMER ON» ().
4. PREV NEXT, CLOCK.
5. PREV NEXT, CLOCK.
13
6. «TIMER OFF»; CLOCK, «TIMER OFF» (
).
7. PREV NEXT, CLOCK.
8. PREV NEXT, CLOCK.
9. «TIMER» , .
10. «TIMER» .
«Snooze»
SNOOZE , 5 .
–10, ,
.
.
, , .
FM: 88 – 108
AM: 540 – 1600
RMS 3,5
220 , 50
2,5 /3
( x x ) 131 x 270 x 130
( x x ) 212 316 x 180
.
.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Hyundai H-CDM8035 User manual
-
-
-
Hyundai H-CMD7071 User manual
-
-
-
-
-
-