4052495-00 Rev.0
1-F BK
4052495-00 Rev.0
1-F Y
4052495-00 Rev.0
1-F M
4052495-00 Rev.0
1-F C
Epson Perfection 1270
Please read these instructions before using the product.
Unpack Your Scanner
1 Make sure you have everything for your Epson scanner:
2 Remove all packing tape, but leave the large sticker in place.
Install the Software
Wait! Install your software before connecting the scanner to your computer.
1 Insert the scanner software CD-ROM in the CD-ROM or DVD drive.
If the installer does not start automatically, do the following:
• Windows XP: Start > My Computer > Epson.
• Windows 98, Me or 2000: My Computer > Epson > Epson.
2 Follow the on-screen instructions to install the scanner software and
Reference Guide. Note that EPSON Smart Panel
™
installs in several steps.
Note: If you’re using Windows 98 and you see a message asking if you’d like
to restart your system, select No, I will restart my system later.
3 At the end of the installation, click Exit.
4 When you see the Product Registration screen, register your scanner on-line
as instructed.
Connect the Scanner
1 Remove the sticker covering the transportation lock on the bottom of the
scanner. Then slide the lock to the unlock position, as shown below.
Caution: Do not turn the scanner over; this may damage the scanner.
2 Remove the yellow
sticker.
3 Connect the power cord and AC adapter, as shown. Then connect the AC
adapter to the scanner and plug the other end of the power cord into a
grounded electrical outlet.
Caution:
• It is not possible to change the AC adapter’s input or output voltage. If the
label on the AC adapter does not show the correct voltage, contact your
dealer. Do not plug in the power cord.
• Whenever you unplug the scanner, wait at least 10 seconds before
plugging it back in to avoid damaging it.
The scanner turns on and the ] Start button light flashes green. It stops
flashing and turns green when the scanner is ready.
4 Plug the USB cable to the scanner, then to your computer as shown below.
Note: Your scanner may not work correctly if you use a USB cable other than
the one supplied by Epson or if you connect your scanner to a hub system.
5 Restart your system, then remove the CD-ROM.
Scanner Basics
Your First Scan
The ] Start button on your scanner opens
Smart Panel. Here’s how you can use this
button and Smart Panel to scan photos
and save them as files.
1 Raise the scanner cover and place
your photo face down on the glass.
Place the document against the
front edge of the scanner glass
and center it on the arrow,
as shown.
Then close the cover.
2 Press the ] Start button on your
scanner.
Note: If you see a message the
first time you press the ] Start
button, select EPSON Smart
Panel for Scanner, click Always
use this program for this
action, then click OK.
EPSON Smart Panel opens on your computer.
3 Click the Scan and Save icon.
Your document is automatically scanned.
4 Click Next in the Save File dialog box.
5 In the following screen, select a location and file type for your scanned
image, then click Save.
Scanner Buttons
The scanner buttons make scanning easy. Just place your document face down
on the scanner, as described in the previous section, and press the button for the
type of scan you want. Follow the on-screen instructions to finish your task.
} Scan your photos to the Epson PhotoCenter
SM
site
1
If you use AOL
®
for the Internet, log on first.
2 Press the } button on the scanner.
3 Follow the on-screen instructions.
| Attach your photo to an e-mail
1
Press the | button on the scanner. You see your photo on the screen.
2 Click Finish.
3 Select your e-mail program and click Launch (AOL is not supported).
4 Enter the address where you want to send the photo, type in a message, and
click Send.
{ Scan and automatically print a document—just like a
photocopier
1
Make sure your printer is turned on.
2 Press the { button on the scanner.
] Automatically scan your file and open Smart Panel or a
Smart Panel application
1
Place your document or photo on the scanner glass.
2 Press the scanner’s ] Start button and follow the on-screen instructions.
Problems?
First, check the ] Start button light on the scanner.
If your problem is listed here, try these suggestions.
Questions?
Here’s where to look for more answers:
Electronic Reference Guide
• Double-click the Perf1270_1670 Reference Guide icon on your desktop.
On-screen Help for EPSON Smart Panel and EPSON Scan:
• Click the Help button or question mark that appears on the screen when
you’re using these programs.
Epson technical support
• Online support
http://www.latin.epson.com
• Telephone support
* If your country is not listed, contact your distributor or the nearest Epson office.
Before you call, please have the following information ready:
• Product name (Perfection 1270)
• Product serial number (located on the bottom of the scanner)
• Proof of purchase (such as a store receipt) and date of purchase
• Computer configuration
• Description of the problem
Epson is a registered trademark and EPSON Smart Panel is a trademark of Seiko Epson Corporation. Perfection is
a registered trademark and Epson PhotoCenter is a service mark of Epson America, Inc.
General Notice: Other product names used herein are for identification purposes only and may be trademarks of their
respective owners. Epson disclaims any and all rights in those marks.
®®
USB cable
Power cord and AC adapter
Perfection 1270
Software
IMPORTANT!
Leave the sticker in
place until you are
instructed to remove it
Remove
Select a file format
Specify the path to
the folder where you
want to save your
scanned image
Click Save
Scan to
Web
CopyScan to
E-mail
Start
Flashing green Warming up or scanning.
Green Ready to scan.
Flashing red Make sure the transportation lock is unlocked.
Restart your computer and unplug the scanner. Wait
10 seconds, then plug the scanner back in.
If the red light still flashes, contact your dealer or
Epson.
Off Make sure your scanner is connected to your
computer and plugged into a power source.
The New Hardware
Wizard appears on your
screen.
Click Cancel and follow the steps in section 2 to
install your software. Disconnect the scanner before
you install.
The scanner makes a
grinding noise when it is
plugged into a power
source.
Make sure the transportation lock is unlocked.
You see an error
message when you try
to scan or the scanner
doesn’t scan.
Make sure your scanner is connected to your
computer and plugged into a power source.
Make sure the transportation lock is unlocked.
Uninstall and reinstall EPSON Scan. See your
on-screen Reference Guide for instructions.
Country* Telephone number Country* Telephone number
Argentina
Chile
Colombia
Costa Rica
(54-11) 4346-0300
(56-2) 200-3400
(57-1) 523-5000
(50-6) 210-9555
(1-800) 377-6627
Mexico
Mexico City
Other Cities
Peru
Venezuela
(52-55) 1323-2000
01-800-087-1080
(51-1) 224-2336
(58-212) 240-1111
Start Here