Introduction：
The San Hima bike hitch carrier can be directly attached to the 2 inch hitch receiver of your
vehicle, and your bike will be kept secure and safe without any wobbling or moving thanks to
the heavy-duty anti-rattle stabilizer attached. This bike hitch mount is compatible with all 2
inch hitch receivers and allows you to load and unload your bikes in a breeze. Moreover, it is
engineered to accommodate 2 bikes at a time, a bonus for cycling enthusiasts and could effec-
tively prevent bikes from colliding with each other.
Safety Precaution:
1. Check the tightness of all bolts and knobs periodically.
2. Check straps periodically and replace them if worn.
3. Your vehicle must have a 2 inch hitch receiver.
4. The bike hitch carrier can hold up to 2 bike with a combined weight of 80 lbs
5. Failure to use safety strap may damage bicycles.
6. If the bike hitch carrier has straps, make sure to securely tighten them every time you use
the rack. Check them frequently when you take a break from driving because they may loosen.
7. If you drive on a bumpy or dirt road while transporting a bicycle, reduce your speed. Rough
roads and vibrations can jostle the bike and the bike hitch carrier, which can loosen them.
Carry arm assembly
Upper Post
Lower Post
Wrench
Warranty：
San Hima warrants that each of its bike hitch carrier that is purchased while this
Warranty is in effect will be free from defects in materials and workmanship for a period
of 1 year from the date of receiving the product from San Hima or its authorized distribu-
tor/dealer. If a product fails to operate during the 1-year Warranty Period as a result of
defects in materials or workmanship, San Hima will, at its option, repair it, replace it
with the same or similar product, or will issue a refund. San Hima will pay for the cost of
shipping or transportation of a defective component to us.
Any and all warranty coverage does not cover replacement of parts and compo-
nents damaged by abuse, neglect, improper or unreasonable use, crash damage, water
or excessive moisture, chemical damage, improper or infrequent maintenance, acci-
dent, unauthorized alteration or modification or items that are considered consumable.
Instructions：
Insert (lower post) into ("L" shaped hitch), so that
the holes of each part can line up.
Insert (lower post) to ("L" shaped hitch) with
(bolt) and (nut).
Insert the latch to the hole of the upper portion of the
"L" shaped hitch and fasten the safety lock so that the
latch won't move.
Connect A (carry arm assembly) to B (upper post),
and first secure them with H (bolt), nuts and later fix
them with latch equipped with safety lock that is
preinstalled on the B (upper post).
First insert B (upper post)into C (lower post), then tighten
them with bolts and nuts.
Lock down the tie-down straps.
Connect the hitch insert of D
("L" shaped hitch) to the 2''
hitch receiver of your vehicle
with J (bolt) and K (nut).
NOTE: Please use L (wrench) and allen wrench to tighten nuts.
/
