PAC VOLT-39 User manual

  • Hello! I am an AI chatbot trained to assist you with the PAC VOLT-39 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Pacific Accessory Corporation
Rev. 122916
VOLT-39
Voltage adapter with selectable
3.3V, 5V, 6V, or 9V output
Introduction and Features
Wiring Overview
Wiring Examples
Tech support: 866-931-8021 | [email protected]
PAC-audio.com
Vehicle’s Reverse Trigger
Chassis Ground
6V Power Output for Camera
BLUE (10V - 24V TRIGGER LOW-CURRENT)
RED (10V - 24V INPUT HIGH-CURRENT)
BLACK (CHASSIS GROUND)
WHITE / RED (REGULATED VOLTAGE OUTPUT)
Radio’s Remote output
12v Constant or Switched
Chassis Ground
5V OEM Amplifier turn on
Low Amperage Trigger
(low-current trigger wire)
(high-current capable supply wire)
Standard Trigger (Most Common)
(high-current capable trigger wire)
The VOLT-39 is a selectable voltage adapter which can accept an input voltage from 10V to 24V and provide a clean output of
3.3V, 5V, 6V or 9V for powering your automotive components or accessories.
No programming is required, simply set the 4-position switch to the desired voltage output, and wire VOLT-39 into your installation.
The VOLT-39 can supply up to 2 Amps of power at 3.3V, 5V or 6V, and is capable of supplying up to 1.5 Amps at the 9V setting.
Example setup when powering a device like an OEM reverse camera.
Example setup when powering a device like an OEM amplifier.
Blue 10V - 24V trigger input - this wire is the trigger wire to ac vate or turn-on the VOLT-39
Red Power input (high-current supply wire) - connect to 12V constant or switched power
Black Chassis ground - connect to chassis ground
Red / White Regulated voltage output - connect this to the low voltage device to be powered by the VOLT-39
Black Chassis Ground - connect to chassis ground
Red / White
Connect to power wire of OEM camera to be
powered with 6V
Blue and Red wires
Connect to posi
ve lead on reverse bulb to ac vate
a camera when the vehicle is shi
ed to reverse
Blue Connect to radio's 12V Remote output wire
Red Connect to 12V constant or switched power
Black
Chassis Ground - connect to chassis ground
Red / White Connect to OEM amplier 5V input turn-on wire
/