Step 1
Place the table top (C), table legs (A) and connector (B) on
a soft, non-abrasive surface such as cardboard or a blanket.
Step 2
See Figures 1 and 2. Use the wrench (EE) to attach the table
legs (A) to the connector (B) with 8 M8x20 bolts (AA), M8
washers (CC) and lock washers (BB).
Step 3
See Figure 3. Use the wrench (EE) to attach the assembled
table base to the table top (C) with 4 M8x20 bolts (AA), M8
washers (CC) and lock washers (BB).
Step 5
See Figure 4. Turn the table upright and use the umbrella
cap to cover the umbrella hole.
Step 4
Fully tighten all bolts and apply bolt head caps (DD) to
each bolt.
Assembly Instructions
Take a deep breath and keep a clear spot nearby
where you can place the small pieces.
Note: Do not fully tighten the bolts until you’ve completed the
assembly and checked to see if the alignment is correct.
Parts
Part NameItem
B
A
Part Picture Qty
2
1
Table Leg
Connector
C 1Stone Table Top
D 1Umbrella Cap
Hardware Kit
Part Name Part Picture Qty
Bolt
M8x20
12
Lock Washer
Bolt Head Cap
Wrench
M8 Washer
1
12
12
12
Item
AA
CC
DD
EE
BB
Your Mission Is Complete.
May every outdoor dinner party be as full of character as this table.
Figure 4
A
C
B
D
A
A
C
BB
CC
AA
A
B
A
B
A
CC
BB
AA
AA
BB
CC
B
A
A
B
A
Figure 1
Figure 2
Figure 3