Sytech SYX200B Owner's manual

Brand: Sytech

Model: SYX200B

Type: Owner's manual

Parts: Charge:

Initial set up via Bluetooth

1. Turn on the Bluetooth™ Speaker by pressing on the top surface as shown in the above diagram. Slide the switch button to the “Bluetooth” mode. “ .

2. Wait for approximately 20 seconds, The speaker will go into pairing mode and will produce a “beep” tone. The top red and blue led light will start flashing alternately.

3. Turn on a device such as an Ipod, Iphone, Tablet, or any other device which include the Bluetooth function. Search for the Bluetooth Speaker device and when SY-X200B appears on your

device, click on it to pair the device with the SY-X200B. The device is now connected and paired with the speaker. If the device asks for a pair code, enter:”0000”

4. If pairing is not successful within 150seconds,the system will search for the last paired device. To restart the pairing process, turn off the speaker and repeat step 1.If the initial set up

connection is successful, the next time the speaker is turned on, it will automatically pair to the last device it was connected with.

5. The SY-X200B does not include a volume control and therefore the volume level can only be controlled from the device and not from the speaker.

NOTE:

1. The SY-X200B speaker can only connect to one device at a time. Turn off the Bluetooth speaker in order to pair the device with another Bluetooth device.

2. The maximum transmission between the Bluetooth speaker and a device is 10 meters or 32 feet.

3. Interference may occur during playback when using the Bluetooth function near other wireless devices. If playback through Bluetooth is problematic, move the speaker and the

playback device to a different location, or use the 3.5mm audio cable jack instead of the Bluetooth function.

WARNING:

BLUETOOTH SPEAKER MANUAL SY-X200B

1,USB charge port

2,Switch button between

BT or cable connection.

It is important to fully charge the speaker before use. The charging process should last from 3 to 4 Hours. The playback

time will last for 4 to 5 Hours when battery is fully charged.

Connect the speaker to the PC via the provided USB cable

When the top RED LED flashes approximately 15 times, it means the battery is low, please recharge the speaker. The

solid RED LED will appear when speaker is on and charged. The RED LED goes out when charging process has finished

The built-in rechargeable battery is not replaceable. Do not remove or replace the battery. Dispose of the unit properly. Do not dispose the unit in trash or fire.

Connecting with an audio cable

To connect the speaker by the cable, simply slide the switch button to the audio input and connect the bottom

Extended 3.5mm audio jack to the music device.