NuTone IS-419 SERIES Installation guide

Brand: NuTone

Model: IS-419 SERIES

Type: Installation guide

NuTone IS-419 SERIES is a 5" Patio Speaker designed for recess-mounting using NuTone Model IR-50 or IR-55 Rough-In Frames (sold separately). It can be installed during new construction or in existing construction, and requires a cutout to the finished wall. The speaker connects to a master unit via six screw terminals, and must be caulked with a waterproofing compound for outdoor use. Once installed, the speaker can be used to enjoy audio in outdoor areas such as patios and decks.

READ & SAVE THESE INSTRUCTIONS!

INSTALLATION INSTRUCTIONS

5" Patio Speaker

MODEL: IS-419 SERIES

• Recess-mounted using NuTone Model: IR-50 Rough-In

Frame.

• When an enclosed rough-in is desired,

use NuTone Model: IR-55 Rough-In Frame.

• Rough-In Frame(s) are sold separately.

ROUGH-IN FRAME MOUNTING

The speaker is mounted to the IR-50 or IR-55 Rough-In

Frame.

NEW CONSTRUCTION

NOTE: Refer to the instructions packaged with the

rough-in.

The rough-in frame is mounted to a wall stud during

rough-in construction. The wiring is ran from the master unit

to the speaker location. The speaker is then mounted to the

rough-in frame once the wall is in place.

EXISTING CONSTRUCTION

NOTE: Refer to the instructions packaged with the

rough-in.

The rough-in frame requires a cutout to the finished wall.

The frame may be mounted either directly to a wall stud or

between the wall studs. The wiring is installed through the

existing wall.

WIRING CONNECTIONS

1. Refer to Figure 1. Remove plastic clip that holds the

rubber gasket to the printed circuit board.

2. Refer to Figure 2. As illustrated, connect wires from the

master unit to the six (6) screw terminals. Red wire to the

terminal marked red, red/white wire to the terminal marked

red/white, etc.

3. Refer to Figure 3. Fold rubber gasket over installed wiring.

Hold gasket tab to printed circuit board by folding tab over

and sliding the removed plastic clip over tab and printed

circuit board.

PLEASE SEE OTHER SIDE

FIGURE 1

FIGURE 2

FIGURE 3

GASKET TAB

IS-419

PRINTED

CIRCUIT

BOARD

PLASTIC

CLIP

RED

RED/WHITE

BLACK

BLACK/WHITE

ORANGE/WHITE

PRINTED

CIRCUIT

BOARD

PLASTIC CLIP

GASKET TAB

IW-6 CABLE

RUBBER

GASKET

ORANGE

MOUNTING

Refer to Figure 4.

1. Carefully place wires inside wall.

2. IMPORTANT: This Patio Speaker must be caulked with a

waterproofing compound (Silicone Rubber, RTV or

equivalent - not supplied by NuTone). Caulk across the top

and both sides of the unit only; the bottom of the unit

should not be caulked.

3. Using two (2) mounting holes in the sides of the speaker

body, secure the speaker to the frame with the two (2)

screws provided.

Refer to the Radio-Intercom system's Operator's Manual

for operating instructions and warranty information. If

Operator's Manual has been misplaced, write to: NuTone,

Madison and Red Bank Roads, Cincinnati,

Ohio 45227. Attention: Department of National Field Service.

Product specifications subject to change without notice.

Madison and Red Bank Roads, Cincinnati, Ohio 45227

Printed in U.S.A., Rev. 2/00, Part No. 43733

FIGURE 4

IR-50

IS-419

SPEAKER

NuTone IS-419 SERIES Installation guide

NuTone IS-419 SERIES Installation guide

NuTone IS-419 SERIES Installation guide

Related papers