ESAB Transmatic 4C User manual

Category
Welding System
Type
User manual

ESAB Transmatic 4C designed for MIG/IMAG welding with the OrigoMig 405 power source. It can be used with wire on wire bobbin with diameter of 300mm or on ESAB’s MarathonPac™.

The device can be installed at the power source, above work position, on the floor with or without wheels or on a support arm.

This feed unit provides the following settings:

  • Wire feed speed in a range of 15-22.0 m/min
  • Burnback time in a range of 0-0.07s
  • Spot welding time in the range of 0.02-0.58s

Additionally, Transmatic 4C offers features like:

  • Creep start switch
  • Control of gas valve
  • Motor driving and braking

ESAB Transmatic 4C designed for MIG/IMAG welding with the OrigoMig 405 power source. It can be used with wire on wire bobbin with diameter of 300mm or on ESAB’s MarathonPac™.

The device can be installed at the power source, above work position, on the floor with or without wheels or on a support arm.

This feed unit provides the following settings:

  • Wire feed speed in a range of 15-22.0 m/min
  • Burnback time in a range of 0-0.07s
  • Spot welding time in the range of 0.02-0.58s

Additionally, Transmatic 4C offers features like:

  • Creep start switch
  • Control of gas valve
  • Motor driving and braking
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28

ESAB Transmatic 4C User manual

Category
Welding System
Type
User manual

ESAB Transmatic 4C designed for MIG/IMAG welding with the OrigoMig 405 power source. It can be used with wire on wire bobbin with diameter of 300mm or on ESAB’s MarathonPac™.

The device can be installed at the power source, above work position, on the floor with or without wheels or on a support arm.

This feed unit provides the following settings:

  • Wire feed speed in a range of 15-22.0 m/min
  • Burnback time in a range of 0-0.07s
  • Spot welding time in the range of 0.02-0.58s

Additionally, Transmatic 4C offers features like:

  • Creep start switch
  • Control of gas valve
  • Motor driving and braking

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI