ESAB Transmatic 4C designed for MIG/IMAG welding with the OrigoMig 405 power source. It can be used with wire on wire bobbin with diameter of 300mm or on ESAB’s MarathonPac™.

The device can be installed at the power source, above work position, on the floor with or without wheels or on a support arm.

This feed unit provides the following settings:

• Wire feed speed in a range of 15-22.0 m/min
• Burnback time in a range of 0-0.07s
• Spot welding time in the range of 0.02-0.58s

Additionally, Transmatic 4C offers features like:

• Creep start switch
• Control of gas valve
• Motor driving and braking