11818 165th Street, Norwalk, CA90650 U.S.A.
Owner’s Manual
AM4000a
Toll Free: (877)881-3699 Tel: (562)802-3003
www.AirFoxx.com E-mail: info@airfoxx.com
Introduction to your New AM4000a
Page 1
The AM4000a by Airfoxx is one of the most powerful Air Mover / Carpet Dryer / Floor Dryer
available.Its large and powerful 1 hp motor delivers up to 4000 CFM which has been proven to
dry any designated area up to 3 times faster than any other 1/3 HP Dryer. The AM4000a is design
to dry all type of surfaces includes carpets, wet paints, oors, cabinets and more, it also keep the
air ventilated at an enclosed area. The AM4000a comes with a high impact roto molded polyethylene
plastic housing and metal fan for durability, 25’ cable with grounded plug for safety, 3 dierent air
ow speed and 3 standing position so this blower can be tted to any job under any condition. The
AM4000a will be ideal for use at work site, public area, warehouses, workshops, restaurant for air
ventilation, janitorial duties, and for use to dry or cool down any type surfaces.
Before you use your airfoxx unit
• Carefully remove the AirFoxx Unit from the shipping carton. Inspect the unit for
damages that may have occurred during transit. If any damage is spotted on the
blower, please notify the delivery carrier immediately and retain the entire
shipment intact for inspection by the carrier
• Make sure operating area are on level ground, and make sure area are dry
• Make sure the electrical connection have the right voltage intended for this unit.
ONLY use electrical plug that are grounded, and operator must take all safety
precaution to ensure safety before attempt to operate the AirFoxx unit.
Safety Warning
• Keep Children Away- Do not allow children or minor to be around an operating
unit at all times as it might cause fatal injuries. When unit is not operating, it must
be store in a area that is inaccessible to children when not attended
• Keep Unit Grounded- Do not operate the unit without a proper grounding plug
and grounded electrical outlet. A grounding plug is essential in safety that helps
reduce the risk of shock of fire hazards.
• Keep out of water- Keep the unit dry and away from any water. Do not operate
the unit in pooled or standing water. Moisture will increase the risk of electrical
shock and/or fire hazard
• Keep out of Dust and Dirt- Do not operate the unit near dust, dirt or sandy
surface where dust and other debris can be drawn into the intake. Dirty motor
can cause overheat, resulting in fire or electrical shock, small debris that got into
the air inlet will get shoot out by the high speed revolving fan wheel, and will
causes fatal injuries to surround people.
• Keep out of Extreme Weather Conditions- Do not operate the unit during extreme
or non-habitable weather condition such as high wind, rain, thunder storm,
hurricane, tornado etc. Extreme weather condition will result in risk of fire or
electrical shock
• Keep out of Dangerous Area- Do not operate the unit near dangerous area such
as fire, gas, fume, or any hazarded material, doing so might lead to damage of
the unit which might result in injuries for operator and those around the unit.
• Keep Operating Unit on leveled surface- Make sure to keep the unit on level
surface at all times. Do not operate the unit on uneven ground or area that will
potentially allow the unit to tip over. An tip over operating unit might result in fatal
injuries because of the high speed moving parts inside
Page 2
• Keep Power Cord from Damage- Do not operate the unit when there’s any power
cord damage. Check to see if there’s any visible damage on electrical cord each
time before use, if suspected do not operate the unit.
• NO Extension Cords- Do not use extension cord on unit. This is a high power unit
that draws a lot of power to ensure its performance. Therefore using an
extension cord will causes amperage drop which will result in overheating of the
motor and risk or fire or electrical shock.
• Handle unit with care- Do not drop or throw the unit which might result in impact.
Impact can causes damage to internal component which might result in danger to
operator or others around while operating
• Keep all body parts away- Keep all body parts, such as finger, hair etc. away
from the unit during operation. Keep your hair away from the air intake as the
suction power might pull your hair in result in fatal injuries. When a unit is not
operating, make sure the electrical plug is unplug and handle with cautions
• Do not move unit- Do not move unit during operation. High power and high speed
moving parts are inside; moving it during operation might result in injuries. Proper
way to handle the unit would be turn off the unit, make sure the unit comes to a
complete stop, unplug the unit then you can move the unit with caution to desire
location before plugging it back in and operate it again.
• Never leave Unit Unattended- Do not leave operating unit unattended, operating
unit must be monitor by individual with safety precaution and clothing to ensure
the unit is operating safely and away from situation which might lead to risk of
injury
• Never use Speed control Device- Do not use speed control device on this unit, as
it might causes damage to the motor resulting in fire hazard or electrical shock
• Do not Modify- Do not modify the unit in anyway, do not put any addition, and do
not take away any parts from this unit. Do not use this unit other then its original
intent. Any modification, addition, or take away any parts might result in injury
when operating.
• Keep Air Intake / Outlet Clean & Clear- Always check to see if the air intake /
outlet are free from any debris or dust. Make sure unit are unplugs and the fan
wheel is not in motion before conducting this check. Keeping air intake / Outlet
clean is essential to a long lasting unit. Dirty or unit that is clog up will result in
decrease performance, and sometime it will damage the blower and result in
injury.
Limited Warranty
• Airfoxx Products, when purchased from an authorized retailer are warranted
to the original purchaser to be free of defect in materials and workmanship for
a period of one (1) year from the date of purchases. Warranty is valid for
products purchased and used in the US only and used in compliances with
the warrantor’s use and maintenance instructions. Save your carton and
receipt in case of return or warranty service is necessary.
• During the warranty period your Airfoxx products will either be repaired or
replaced, at the warrantor’s discretion, without charge shipping fee will note
be included and would be the purchaser’s responsibility. For service or
warranty call (877) 881-FOXX(3699).
/
