Rev E. 03/09 1 of 4 888-97-011-01
Wall Mount
Bracket Kit
INSTALLATION MANUAL
1
A
1
1x
888-99-014
Rev E. 12/02 1 of 10 888-99-014-02
Ergonomic Mounting Heights
(for Flat Panel Monitors and Keyboards)
ERGONOMICS
Ergotron USA 1-800-383-1916
Ergotron Europe +31 20 312.29.39
Overview
When mounted properly, Ergotron
ARMS™ will provide ergonomic monitor
viewing and keyboard operation for a
wide range of users - whether sitting,
standing or in sit/stand situations.
The dimensioned drawings and formulas
contained in this guide can be used to
determine the ergonomically correct
mounting height of any of Ergotron's
Flat Panel Monitor/Keyboard solutions
mounted to either a vertical or a
horizontal surface. If mounting above
a worksurface, mounting heights may
change due to various worksurface
heights.
The Anthropometric Table on page
10 shows how mounting heights are
calculated based on the eye and elbow
heights of male and female operators.
To Mount your Flat Panel Monitor or Keyboard at an ergonomically
correct height, start at step 1 and continue as directed.
2
1
Center
Line of
mounting
holes
Top
of
Screen
Front View
Back View
X
Side View
X
FIND "x"
1
= Distance between Center line of Mounting Holes and Top of Monitor Screen.
2
1
Applications mounted to a
horizontal surface
Applications mounted to a 1.5" pole
FIND YOUR MOUNTING APPLICATION
2
2
6
6
6
8
9
9
9
USE "x"
to calculate mounting height for your application.
HD Laptop
Tray
3
8
2 33
4 5
77
888-97-011-01 2 of 4 Rev E. 03/09
2
NOTE: The Wall Mount Bracket is not
shipped with mounting hardware. The
building engineer must determine the
proper attachment method.
WARNING: The Ergotron Wall Mount Bracket
must be securely attached to your wall. Because
wall construction varies widely and your ultimate
mounting method is out of Ergotron’s control, it
is imperative that you consult with appropriate
local engineering, architectural, or construction
personnel to ensure that the Wall Mount Bracket
is mounted properly to handle applied loads.
!
.281 Dia. wall
mounting holes
#10-24 UNC
tap (10) holes
#8-32 UNC
tap (4) holes
7.375"
(187.33mm)
.50"
(12.7mm)
.50"
(12.7mm)
2.50"
(50.8mm)
1.25"
(25.4mm)
Flat Panel
Extender
Arm
400 Series
Arms
200 Series
& LX Arms
100 Series
Direct Pivots
Rev E. 03/09 3 of 4 888-97-011-01
3
400 Series Arms
100 Series Direct Pivots
200 Series & LX Arms
Flat Panel Extender Arm
888-97-011-01 4 of 4 Rev E. 03/09
/