Eurolux PR115 Owner's manual

Type
Owner's manual
Recessed Fitting with Opal Diffuser
ILLUSTRATIONS
PR115 / PR116
PRODUCT CODE
Please read instructions before commencing installation and retain for
future reference.
ENVIRONMENTAL PROTECTION
Waste electrical & Electronic equipment regulations requires that any of our products showing this
marking must not be disposed of with other household or commercial waste. To prevent possible
harm to the environment or human health from uncontrolled waste disposal, please separate any
such products from other waste types and recycle it responsibly at your local facilities.
Cape Town - 9 Racecourse Road, Milnerton, 7441
Johannesburg - 10 Milkyway Avenue, Linbro Business Park, Sandton, 2065
email: [email protected], web: www.eurolux.co.za
PR116: Excluding 3 x G5 maximum 28W T5 Fluorescent tubes
PR115: Excluding 3 x G5 maximum 14W T5 Fluorescent tubes
Switch off the power supply before installation (1)
Press the spring stator (2)
Remove the diffuser (3)
Connect the main to terminal block (4)(6)
Install lamps (5)(7)
Re - Install and lock diffuser back into place (8)
Fitting Materials:Cold-rolling steel with white powder coated body & Opel diffuser
Lamp type:
PR115: Excluding 3 x G5 maximum 14W T5 Fluorescent tubes
PR116: Excluding 3 x G5 maximum 28W T5 Fluorescent tubes
Voltage: 220V - 240V ~ 50Hz
Protection against electric shock: Class 1. Require earthing connection
IP Rating: 20. Dust Protected. Protected against solid foreign objects of 1.0mm Ø and greater
Protected against splashing water.
Maximum Ambient temperature range: 20ºC - 40ºC
•Commercial/domesticuse
•Notsuitableforoutdooruse
•Notforuseinareasexposedtomoisture
Dimensions:
PR115: (L)600mm x (W)600mm x (D)80mm
PR116: (H)1200mm x (W)600mm x (D)80mm
•Cut-Out:
PR115: (L)570mm x (W)570mm
PR116: (L)1170mm x (W)570mm
Additional Information:
PR115 Including 1 x (2x14W) Electronic
1 x 14W Cotrol gear
PR116 Including 1 x (2x28W) Electronic
1 x 28W Control gear
2 years warranty
PR115/PR116- Attachments:
Iftheexternalexiblecableorcordofthisluminaireisdamaged,itshouldbeexclusivelyreplaced
bythemanufacturerorhisserviceagentorasimilarqualiedpersoninordertoavoidahazard.To
ensure that you get maximum longevity and maximum use out of your luminaire, please observe
the following safety instructions.
Electrical products can cause death, injury, or damage to property. Installation of the luminaire
mustbecarriedoutbyaqualiedelectrician,inaccordancewithSANS10142.Oncompletion
ofinstallation,ensurethattheCerticateofComplianceisupdated.
•Beforeconnectingthisluminaire,ensurethatvoltageindicatedontheratinglabelcorresponds
with the mains voltage in your home.
•Whenchangingthelamp,ensurethatthepoweristurnedoff.
•Thisluminaireischeckedinfullforconformitytothequalitystandardsandsafetyrequirements.
•Themanufacturer/supplierisnotresponsibleforanydamageofpropertiesandpersons,
caused by the incorrect use or installation of the luminaire.
•Shouldyoubeunsureofhowtoinstallthisluminairecorrectly,pleaseconsultaprofessional
electrician or your supplier for assistance.
•Ensureallitems/components,threadsandscrewsaretightlysecured.
SPECIFICATIONS
IMPORTANT SAFEGUARDS
INSTALLATION
CLEANING
•Beforecleaningalwaysensurethepowersupplyisturnedoff.
•Donotimmersetheluminaireinwater.
•Noabrasiveproducts,solvents,detergentmaybeusedtocleanthisluminaire.
•Ensurethatthettingdoesnotcomeincontactwithcorrosivechemicals,etc.
•Coastalareasensurethattheluminaireiscleanedfortnightly.
Installation:
Switch the power off before commencing with the installation.
•Whendrillingisrequireforxingtheluminairetotherequiredsurfacepleaseensurethatno
pipes or cables are within the drilling area.
•Connectthewiresasshowningure
•Iftheheatsleeveissuppliedwithyourluminaire,pleaseconnecttheincominglive,Neutraland
Earth supply wires.
•Connecttheearth(green/yellow)supplywiringtotheearthterminal
•Connectthelive(brown/Red)Supplywiringtotheconnectorblockmarked
•Ensureallitems/components,threadsandscrewsaretightlysecured
•Ensurethelampsareseatedcorrectly.locateandtwist.
•Mounttheuppercoverandxitinplacewiththescrews.
Changing the lamp:
Switch the power off before commencing with the installation.
1. Always ensure the lamp has been allowed to cool before attempting to change the lamp.
2. Open the luminaire cover.
3. Carefully unscrew the lamp.
4. Carefully screw in the new replacement lamp.
5. Close the luminaire, fastening any loose screws before re-connecting the electricity and
turning the luminaire on.
IMPORTANT:
•Tamperingwiththisluminaire,IE.Usingsiliconsealersorincorrectcabling,willinvalidate
your warranty.
•Whentheprotectionglassisdamaged,itshouldbereplacedimmediately.Theluminairemust
not be used without the protection glass.
•Pleasecheckwhethertheconnectionofthepowercordissafeandreliablebeforeinstallation.
•Alwaysensurethatthemainssupplyvoltageiscorrect.
•Alwaysreplacethelampwithoneofanidenticalrating.
•Ensurethatyoudonotplacetheluminairenearanycombustiblematerialsand/orsurfaces.
•Chokinghazard:Maycontainsmallparts.Keepawayfromchildren.
•Donotinsertyourngersoranypartofyourbodyintotheelectricalcontactandsocketsofthis
product whilst it is connected to the electricity supply.
•Itemmayvaryslightlyfromthepictureonthecarton.
  • Page 1 1
  • Page 2 2

Eurolux PR115 Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI