2. ESi Ergo
  3. FCH9-POD-PNK

ESi Ergo FCH9-POD-PNK, FCH9-POD-WHT Operating instructions

  • Hello! I've analyzed the instructions for the FLEXCHARGE9 RING. This document outlines the process of switching out the plastic cover ring. It provides guidance on removing the old ring and installing the new one with detailed instructions. I am ready to answer your questions about the cover ring replacement.
  • What should be done before starting to replace ring?
    How should I remove the outer cover ring?
    How to install the new outer cover ring?
Instructions
FLEXCHARGE9 RING
Switching out the plastic cover ring
REMOVING THE OUTER COVER RING: INSTALLING THE OUTER COVER RING:
3. Use your ngers to pry the ring off of the
FlexCharge9. The ring will lift off from the unit.
3. Ensure that the ring is centered on all tabs and
completely level.
4. Place your hands on either side of the unit.
Gently press down on the unit to secure the ring
into place.
5. The FlexCharge9 is now ready to use.
© 2017 ESI. All Rights Reserved. FCH9-RING 9/17
1. Make sure the unit is unplugged from any
power source.
1. Make sure the unit is unplugged from any
power source.
2. Place your hands on both sides of the
FlexCharge9 unit.
2. Line up the ring protrusions with FlexCharge9
holes as seen below.
4. The FlexCharge9 will look like this without the
outer ring:
/