2. FSR
  3. VWP-SVA-WHT

FSR VWP-SVA-WHT, VWP-SVA-BLK, VWP-SVA-SF Owner's manual

  • I have analyzed the provided document, which contains the instructions on how to prepare a power supply by cutting the connector, stripping the insulation from the wires, paying attention to polarity for DC products, and more. I'm ready to answer your questions about the power supply.
  • What should I do with the connector on the power cord?
    How much insulation should I strip from the end of the wires?
    Which wire is positive for DC products?
OF
REV.
PART#
DATE:
PRODUCT:
DWG.#
DRAWN BY:
APPROVED
REV. LEVEL REV. DATE
DESCRIPTION
PAGE
APPROVED BY:
DATE:
REF. ECO
1 1
RLK
C-1026A
03/12/09
POWER SUPPLY PREPARATION
POWER SUPPLY PREPARATION
2) Strip insulation 3/16 inch from end of wires.
1) Cut connector off of supply power cord, if so equipped.
On products with a DC only input,
Polarity is important. Wire with
dashed white line is positive.
For product with a 12 VDC/9 VAC Input,
either polarity may be used.
43099
TERMINATION STYLE
MAY VARY
POWER SUPPLY STYLE
MAY VARY
/