Rugged Ridge Fog Light Euro Guards Installation guide

  • Hello, I am a chat assistant and I have reviewed the provided document. This document describes how to install Rugged Ridge Fog Light Euro Guards models 11231.13 and 11142.13 on a Jeep JK Wrangler. It provides step-by-step instructions including placing O-rings, removing screws, installing guards and reinstalling fog lights. I can assist you with any questions you may have about the installation process.
  • How many screws secure each fog light?
    What should be placed around the perimeter of each Euro Guard before installation?
    What should be the orientation of the Euro Guard's bars when installed?
11231.13 (Black)
11142.13 (Stainless Steel)
Jeep® JK Wrangler Fog Light Euro Guards
Contents:
Fog Light Euro Guards (2)
O-Rings (2)
Page 1 of 2
1. Place O-Rings around perimeter of each Euro Guard to prepare
for installation.
2. From underneath vehicle, locate the 4 philips head screws that
secure each fog light to the bumper. Unscrew these screws and
and set them aside to be reinstalled later. It may be easier to access
these screws if the factory plastic air dam is removed first.
3. Insert Euro Guards into fog light opening such that the O-Ring is
in contact with the bumper. The bars of each Euro Guard should be
vertical.
Page 2 of 2
4. Reinstall fog lights and tighten all screws. It may be helpful
to have someone hold the Euro Guards in place from the front
of the bumper while the screws are tightened from the back.
5. From the front of the vehicle, check to make sure O-rings
are properly seated between the Euro Guards and the bumper.
/