Barco CRWQ-62B Quick start guide

Brand: Barco

Model: CRWQ-62B

Category: Projector mounts

Type: Quick start guide

This manual is also suitable for

Kit ContentsKit Contents

Exhaust Air Kit Quick Start Guide

4

3

2

1

General

601-0290-02

The exhaust air kit, R9801376/R9801377, is an accessory for the F32-, F33-,

and F35-series projectors only.

This exhaust kit must only be used with ceiling mounted projectors.

Do not try to force parts into position! If there is resistance, remove the

part, reposition and try again.

1. Verify installation requirements

The installation must meet, as a minimum, the

physical requirements speciﬁed below.

2. Remove cabinet screw

Remove the cabinet screw directly above the LCD

screen at the rear of the projector. Store safely for

future use.

3. Install duct to projector

Slide the exhaust duct clips into the projector

ventilation grid and then snap the duct into position.

Fasten using the M4x12 screw from the kit. Do not

overtighten the screw!

4. Install ﬂexible hose to duct

Thread the ﬂexible hose* onto the exhaust duct and

fasten it in place with the hose clamp.

When the exhaust is to be directed into a false ceiling: The area must be

well-ventilated but this ventilation must not override the projector’s

internal fans.

AMB TEMP:

40°C @ 0 mamsl

35°C @ 1500 mamsl

EXHAUST TEMP:

45°C @ 0 mamsl, 20°C

65°C @ 1500 mamsl, 40°C

Minimum distance between Projector

and Ceiling: 150mm

Printed on FSC certied paper (www.fsc.org)

1

Installation Guidelines

Installation Sequence

M4x12 screw

Exhaust air duct

Hose clamp

Flexible hose* Ø125 mm

* Max. length 150cm

4

1

3

2

1

Barco CRWQ-62B Quick start guide

Brand: Barco

Model: CRWQ-62B

Category: Projector mounts

Type: Quick start guide

This manual is also suitable for

Download PDF

Related papers

Other documents