Minka-Aire F899L-ORB User manual

Type
User manual

This manual is also suitable for

REMOVING THE 24W LED ASSEMBLY
FROM LIGHT KIT PLATE
14
24W LED assembly (preassembled)
Light kit plate
REMOVING THE 24W LED ASSEMBLY FROM LIGHT KIT PLATE
Step 1. Remove the screw from circular hole and loosen the other three screws from key
holes approximately 1/4 turn. Keep the screw that removed aside for use later.
Step 2. Turn the key holes of the 24W LED assembly from the three screws loosened
previously and remove the 24W LED assembly from light kit plate. (Fig.16)
Light kit plate
24
Step 3. While holding the 24W LED assembly under your fan, firmly snap
the wire connection plugs together. (Fig.18)
Step 4. Place the key holes from 24W LED assembly over the 3 screws
previously loosened from the light kit plate.
Turn the 24W LED assembly until it locks in place at the narrow section
of the key holes. Secure by tightening the three screws previously
loosened and the one screw previously removed. (Fig.18)
24
Light kit plate
Light kit plate
Step 2. Place the key holes from the Light kit plate over the 2 screws
previously loosened from the mounting ring, turn Light kit plate until it
locks in place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one previously
removed. (Fig.17)
19
19
Light kit plate
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28

Minka-Aire F899L-ORB User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI