REMOVING THE 24W LED ASSEMBLY
FROM LIGHT KIT PLATE
14
24W LED assembly (preassembled)
Light kit plate
REMOVING THE 24W LED ASSEMBLY FROM LIGHT KIT PLATE
Step 1. Remove the screw from circular hole and loosen the other three screws from key
holes approximately 1/4 turn. Keep the screw that removed aside for use later.
Step 2. Turn the key holes of the 24W LED assembly from the three screws loosened
previously and remove the 24W LED assembly from light kit plate. (Fig.16)
Light kit plate
24
Step 3. While holding the 24W LED assembly under your fan, firmly snap
the wire connection plugs together. (Fig.18)
Step 4. Place the key holes from 24W LED assembly over the 3 screws
previously loosened from the light kit plate.
Turn the 24W LED assembly until it locks in place at the narrow section
of the key holes. Secure by tightening the three screws previously
loosened and the one screw previously removed. (Fig.18)
24
Light kit plate
Light kit plate
Step 2. Place the key holes from the Light kit plate over the 2 screws
previously loosened from the mounting ring, turn Light kit plate until it
locks in place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one previously
removed. (Fig.17)
19
19
Light kit plate
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/