Replacement Guide

Copyright Information

©2010 Promethean Limited. All rights reserved.

This guide is distributed for the ActivBoard Audio Amplifer. It may only be reproduced for use within the institution

in which the product is used. For use outside of your institution, no part of this guide may be reproduced, transmitted,

stored in a retrieval system or translated into any other language without the prior permission of Promethean Limited.

Please note that the content in this guide is protected under copyright law. Although every care has been taken in the

compilation of this guide, Promethean Limited accepts no responsibility for errors or omissions.

2 Audio Amplifier Replacement Guide

Amplifier or Loud Speakers.

The existing Audio Amplifier is located at the

left hand side of the ActivBoard as viewed from

the front.

Looking from the rear, disconnect the three

connections to the Audio Amplifier as shown

opposite.

Replacement Guide

Audio Amplifier Replacement Guide 3

Remove the existing Audio Amplifier by

Engage the replacement Audio Amplifier

with the mounting rails and slide the card

into position.

Push the Audio Amplifier as far as it will go to

ensure correct connection is made.

Secure the Audio Amplifier to the ActivBoard

with the two screws that were previously

removed. Do not over tighten.

Finally, refit the three connections

removed earlier.