Lightolier IS-CWLPC120 User manual

Brand: Lightolier

Model: IS-CWLPC120

Type: User manual

Lightolier is a Philips group brand

631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710

We reserve the right to change details of design, materials and finish.

Architectural Decorative IS-CWLPC120

Page 1 of 1 Instruction Sheet for Assembly and Installation

Read and understand these instructions before installing luminaire

This luminaire is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and

regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

1. Remove knockout from junction box. (Fig. 1)

2. Slide strain relief at least six inches in from lead end of leader cable.

(Fig. 2)

Tighten two screws on the strain relief clamp to lock it in place.

3. Pass cable though knockout and slide strain relief nut down cable.

(Fig. 3)

4. Tighten nut to lock strain relief in place. When properly installed,

strain relief should look like this (Fig. 4):

At least six inches

Leader cables for concealed white luminaires installed in North America must, in order to comply with

Underwriters Laboratories rules for installation, have a strain relief on the leader cable where it emerges from