Lightolier is a Philips group brand
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
www.lightolier.com © 2008 Philips Group • B1008
Architectural Decorative IS-CCL06WF12
Page 1 of 3 Instruction Sheet for Assembly and Installation
Read and understand these instructions before installing luminaire
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and
regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
A
Luminaires must be installed by a qualified
electrician in accordance with all national and local
electrical and construction codes and regulation.
Terminator
Concealed
Color LED Adjustable
Jumper Cable
Leader Cable
Power Supply
1 ft (305 mm)
CCLJC12
—
5 ft (1.5 m)
CCLJC60
Make sure power is OFF
Installation Example
CCL12WF12
—
CCL12NF12
—
CCL06WF12
—
CCL06NF12
CCLPS602P
—
CCLPS608P
30 ft (9.1 m)
CCLPC360
Architectural Decorative IS-CCL06WF12
Page 2 of 3 Instruction Sheet for Assembly and Installation
Lightolier is a Philips group brand
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
www.lightolier.com © 2008 Philips Group • B1008
Click!
OK
Mounting Options
1 ft (305 mm)
CCLJC12
—
5 ft (1524 mm)
CCLJC60
Connect additional luminaires
either luminaire-to-luminaire
or via Jumper Cable
Attach Terminator Turn the power ON
Direct Luminaire Mounting Track Mounting
Direct Luminaire Mounting
with Track
25 @ 4 ft (1219 mm)
CLMT2548
Architectural Decorative IS-CCL06WF12
Page 3 of 3 Instruction Sheet for Assembly and Installation
Lightolier is a Philips group brand
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
www.lightolier.com © 2008 Philips Group • B1008
Address Luminaires – Refer to Power / Data Supply Manual
LED RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LED PRODUCT
CAUTION
TEST STANDARD: IEC 60825- : 993+A : 997 +A2: 200
BLUE LED WAVELENGTH: 469nm
GREEN LED WAV ELENGTH: 5 9nm
RED LED WAVELENGTH: 624nm
MAXIMUM OUTPUT OF RADIATION: 2.8mW
Non-replaceable LED
A Verify power is off before installing or de-installing.
B Do not attempt to install or use until you read and understand the
installation instructions and safety labels.
B Luminaires have line voltage risk of shock and no user serviceable parts.
Do not attempt to open them.
B Do not use any voltage or current the product is not rated for.
B Do not use if the product housing or power cables are damaged.
C Do not hot swap luminaires. Ensure that power to the series is off before
connecting or disconnecting individual luminaires.
C Do not modify or alter the product. Doing so will void the warranty.
C Ensure that the device is securely attached, properly mounted, and free of
excessive vibration.
C This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: 1) This device may not cause harmful
interference. 2) This device must accept any interference received,
including interference that may cause undesired operation.
C Use only with CCLPS602P or CCLPS608P Class 2 power supply unit
Item Type Part Number
Concealed Color LED Adjustable 12 inch
(305 mm)
120° X 120° CCL12WF12
100° X 40° CCL12NF12
Concealed Color LED Adjustable 6 inch
(152 mm)
120° X 120° CCL06WF12
100° X 40° CCL06NF12
Mounting Track
25 @ 4 ft (1219 mm) CLMT2548
Leader Cable and Terminator
30 ft (9.1 m) CCLPC360
Jumper Cable
1 ft (305 mm) CCLJC12
5 ft (1.5 m) CCLJC60
sPDS-60ca 60W Power / Data Supply
24V DMX / Ethernet CCLPS602P
/