2. SEAV
  3. IT/IR 2126

SEAV IT/IR 2126 User guide

  • Hello! I am an AI chatbot trained to assist you with the SEAV IT/IR 2126 User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
BUILT-IN PHOTOELECTRIC CELL IR/IT 2126
Modulated infrared barrier .
Operating with opposed transmitter and receiver. Double safety relais (one energised and one die-energised).
Technical data:
- Max. nominal load : 40 meters
- Power supply : 12-24V AC-DC
- Consumption pair ( IT + IR ) : 2W
- Working temperature : -10 55 °C
- Container : ABS
- Protection degree : IP 54
- Dimensions : see fig. 1
IT 2126 Transmitter:
- Modulation frequency : 1000Hz
- Infrared wave length : 950nm
IR 2126 Receiver:
- Relais contacts : 1A max a 30 VDC
- Output contact normally open : NA
- Output contact normally closed : NC
- Red Led that is when the photocells are aligned
Fig. 1
Terminal board connections: (fig. 2)
Fig. 2
Installation
• Open the photocell box and fix the back part to the wall using the four holes .
• Connect the cables to the terminal board following the scheme (fig. 2).
• Fix the internal body with the three A screws (fig. 3).
• Use the three B screws (fig. 3) to obtain the alignment of the transmitter with the receiver; the receiver is equipped with a red
internal pilot lamp that is on when both photocells are aligned.
• Tighten the lid with the C screws.
Fig. 3
Rev. 1.1 del 27-02-2007
SEAV s.r.l. hereby declares that the product below: IR/IT 2126 complies with the requirements of Directive EMC
2004/108/EC.
2
/