TC HELICON DUPLICATOR User manual

Brand: TC HELICON

Model: DUPLICATOR

Category: Supplementary music equipment

Type: User manual

DUPLICATOR

Ultra-Simple Vocal E ects Stompbox with

Doubling, Reverb and Pitch Correction

User Manual

2 DUPLICATOR User Manual

Important Safety

Instructions

LEGAL DISCLAIMER

LIMITED WARRANTY

Terminals marked with this symbol carry

electrical current of su cient magnitude

to constitute risk of electric shock.

Use only high-quality professional speaker cables with

¼" TS or twist-locking plugs pre-installed. Allother

installation or modi cation should be performed only

by quali edpersonnel.

This symbol, wherever it appears,

alertsyou to the presence of uninsulated

dangerous voltage inside the

enclosure-voltage that may be su cient to constitute a

risk ofshock.

This symbol, wherever it appears,

alertsyou to important operating and

maintenance instructions in the

accompanying literature. Please read the manual.

Caution

To reduce the risk of electric shock, donot

remove the top cover (or the rear section).

No user serviceable parts inside. Refer servicing to

quali ed personnel.

Caution

To reduce the risk of  re or electric shock,

do not expose this appliance to rain and

moisture. The apparatus shall not be exposed to dripping

or splashing liquids and no objects  lled with liquids,

suchas vases, shall be placed on the apparatus.

Caution

These service instructions are for use

by quali ed service personnel only.

Toreduce the risk of electric shock do not perform any

servicing other than that contained in the operation

instructions. Repairs have to be performed by quali ed

servicepersonnel.

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in

accordance with the manufacturer’s instructions.

8. Do not install near any heat sources such as

radiators, heat registers, stoves, or other apparatus

(including ampli ers) that produce heat.

9. Do not defeat the safety purpose of the polarized

or grounding-type plug. A polarized plug has two blades

with one wider than the other. A grounding-type plug

has two blades and a third grounding prong. The wide

blade or the third prong are provided for your safety. Ifthe

provided plug does not  t into your outlet, consult an

electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or

pinched particularly at plugs, convenience receptacles,

and the point where they exit from the apparatus.

11. Use only attachments/accessories speci ed by

themanufacturer.

12. Use only with the

cart, stand, tripod, bracket,

or table speci ed by the

manufacturer, orsold with

the apparatus. When a cart

is used, use caution when

moving the cart/apparatus

combination to avoid

injury from tip-over.

13. Unplug this apparatus during lightning storms or

when unused for long periods of time.

14. Refer all servicing to quali ed service personnel.

Servicing is required when the apparatus has been

damaged in any way, such as power supply cord or plug

is damaged, liquid has been spilled or objects have fallen

into the apparatus, the apparatus has been exposed

to rain or moisture, does not operate normally, or has

beendropped.

15. The apparatus shall be connected to a MAINS socket

outlet with a protective earthing connection.

16. Where the MAINS plug or an appliance coupler is

used as the disconnect device, the disconnect device shall

remain readily operable.

17. Correct disposal of this

product: This symbol indicates

that this product must not be

disposed of with household

waste, according to the WEEE

Directive (2012/19/EU) and

your national law. This product

should be taken to a collection center licensed for the

recycling of waste electrical and electronic equipment

(EEE). The mishandling of this type of waste could have

a possible negative impact on the environment and

human health due to potentially hazardous substances

that are generally associated with EEE. At the same time,

your cooperation in the correct disposal of this product

will contribute to the e cient use of natural resources.

For more information about where you can take your

waste equipment for recycling, please contact your local

city o ce, or your household waste collection service.

18. Do not install in a con ned space, such as a book

case or similar unit.

19. Do not place naked  ame sources, such as lighted

candles, on the apparatus.

20. Please keep the environmental aspects of battery

disposal in mind. Batteries must be disposed-of at a

battery collection point.

21. Use this apparatus in tropical and/or

moderate climates.

MUSIC Group accepts no liability for any loss

which may be su ered by any person who relies

either wholly or in part upon any description,

photograph, or statement contained herein.

Technical speci cations, appearances and other

information are subject to change without notice.

All trademarks are the property of their respective

owners. MIDAS, KLARK TEKNIK, LAB GRUPPEN, LAKE,

TANNOY, TURBOSOUND, TC ELECTRONIC, TC HELICON,

BEHRINGER, BUGERA and DDA are trademarks

or registered trademarks of MUSIC Group IP Ltd.

For the applicable warranty terms and conditions

and additional information regarding MUSIC Group’s

Limited Warranty, please see complete details online at

music-group.com/warranty.

3 DUPLICATOR User Manual

1. Controls

(1) (2) (3)

(5)

(4)

(8)

(6)

(7)

(9) (10)(11)(12)

(1) DOUBLING knob selects the type and amount of doubling e ect on your

voice. The  rst two types allow a tight voicing that has less variation from

your original voice, or loose doubling that varies more in pitch and time.

The 3rd type adds an extra voice an octave below your original note. Adjust

the knob within your preferred e ect type to determine the volume of the

second voice.

(2) REVERB knob selects the type and amount of reverb e ect on your voice.

The 3 types of reverb appear in order from the smallest space (Room) to

the largest (Hall). Adjusting the knob within your preferred reverb space

determines how pronounced the e ect will be. Turning the knob fully

counterclockwise turns the reverb o .

(3) CORRECTION knob adjusts the amount of pitch correction. With the knob

at the center 12:00 position, the e ect will provide subtle pitch support

without noticeable or unnatural artifacts. Turn the knob all the way up for a

more aggressive e ect, or fully counterclockwise to turn the e ect o .

(4) BATTERY LED indicates the battery level, with green showing full life,

yellow being partial life, and red to alert that the batteries

should be changed.

(5) TONE button engages a preset combination of adaptive EQ, compression,

de-essing, and noise gate. "Normal" and "Less Bright" settings can be

toggled by holding the Tone button and pressing the footswitch.

(6) ON/OFF LED lights when the e ect is engaged.

(7) FOOTSWITCH bypasses the doubling e ect, but does not a ect the reverb,

correction or Tone status.

(8) USB input accepts a micro USB cable for connection to a computer.

Use the VoiceSupport application to install  rmware updates, and for

other features depending on your product. Download VoiceSupport from

tc-helicon.com/products/voicesupport/

(9) ON/OFF switch powers the pedal on and o .

(10) POWER input accepts a 9V power cable (not included).

(11) OUT jack accepts a balanced XLR cable for connection to a mixer or

active speaker.

(12) MIC input jack accepts a balanced XLR cable to connect your microphone.

4 DUPLICATOR User Manual

Connection

• Connect a microphone to the MIC jack

• Connect the OUT jack to a mixer, interface or active speaker

• Connect power cable (optional)

• Connect a micro USB cable to a computer (optional)

Momentary Mode

The standard function of the footswitch is a latching style, meaning that each

press of the footswitch turns the doubling e ect on and o . Alternatively, the

switch can operate in momentary mode, meaning that the doubling is only active

while the footswitch is held down. As soon as you release the footswitch, the

doubling e ect is bypassed.

To switch the unit to momentary mode, hold the Tone button down while

powering the unit on. Repeat the process to return to latching mode.

Changing the Batteries

Duplicator can operate on 4 AA batteries. Remove the single screw on the bottom

of the pedal to open the battery door. Make sure to observe correct polarity when

inserting the batteries.

Auto Gain

Duplicator will automatically adjust the gain setting for your microphone,

eliminating the need for manual adjustments and ensuring that a good signal is

passed to the mixer without any unwanted distortion.

24V Phantom Power

Phantom power is always active on the Duplicator. This will power condenser

microphones, but will not a ect dynamic mics either.

Mic Control

Mic Control allows you to control the e ect's on/o status via an MP-75

microphone. Press and hold the footswitch while powering up the unit to

toggle Mic Control.

Note that when using a condenser microphone, Mic Control should be disabled to

prevent unwanted on/o switching.

Micro USB cable

MP-75 microphone

Mixing board

Power cable

2. Operation

5 DUPLICATOR User Manual

3. Speci cations

Input Mic

Input Impedance: Balanced: 2.68 kOhm

Mic Input Level @ 0 dBFS: -42 dBu to +1 dBu

EIN @ Max Mic Gain Rg = 150 Ohm: -126 dBu

Mic input SNR: >104 dB

Output

Output Impedance, Bal./Unbal.: 200/100 Ohm

Output Full Scale: +1 dBu

Dynamic Range: >104 dB, 20 Hz to 20 kHz

Frequency Response: +0/-0.3 dB, 20 Hz to 20 kHz

Power

Power Supply (Optional): 9 V / 670 mA

Power Consumption: 6 W

Requirements

Operating Temperature: 32°F to 122°F (0°C to 50°C)

Storage Temperature: -22°F to 167°F (-30°C to 70°C)

Humidity Max.: 90 % non-condensing

Size & Weight

Dimensions: 5.4" x 3.5" x 2.3" (140 x 90 x 60 mm) Weight: 0.92 lb. (420 g)

Warranty

For th

e applicable warranty terms and conditions and additional information

regarding MUSIC Group’s Limited Warranty, please see complete details

online at music-group.com/warranty.

Due to continuous development, these speci cations are subject to change

without notice

TC HELICON DUPLICATOR User manual

Brand: TC HELICON

Model: DUPLICATOR

Category: Supplementary music equipment

Type: User manual

Download PDF

report

TC HELICON DUPLICATOR User manual

TC HELICON DUPLICATOR User manual

Related papers

Other documents