Features
•
Compression molded from our exclusive solid Vikrell
®
material
•
Tongue-and-groove 4-piece modular design allows for
easy ″snap together″ installation
•
Durable high-gloss finish
•
10-year consumer/3-year commercial limited warranty
•
Compatible with 71121110, 71121120, 71121112, and
71121122
•
Allows for future attachment of grab bars
•
Complete unit rough-in dimensions include flange
•
60-1/4″ (153 cm) x 33-1/4″ (84.5 cm) x 54″
(137.2 cm)
Codes/Standards Applicable
Specified model meets or exceeds the following:
•
ASTM E162
•
ASTM E662
•
CSA B45.5/IAPMO Z124
BATH AND WALL SURROUND WITH
BACKER BOARDS
71120116
ALSO 71120118, 71120126, 71120128
Colors/Finishes
•
0: White
•
Other: Refer to Price Book for additional colors/finishes
Specified Model
Model Complete Unit Description Colors/Finishes
71120116 32″ (81.3 cm) bath and wall surround with backer boards, left drain ❑ 0 ❑ Other_____
71120118 32″ (81.3 cm) bath and wall surround with backer boards, above-the-floor left
drain
❑ 0 ❑ Other_____
71120126 32″ (81.3 cm) bath and wall surround with backer boards, right drain ❑ 0 ❑ Other_____
71120128 32″ (81.3 cm) bath and wall surround with backer boards, above-the-floor right
drain
❑ 0 ❑ Other_____
Model Wall Component Description Colors/Finishes
71124106 Complete wall set with backer boards ❑ 0 ❑ Other_____
ENSEMBLETM
Page 1 of 2
1061193-4-
D
For more information
visit SterlingPlumbing.com
or call 1-800-STERLING
Technical Information
Fixture*:
Basin area:
Bathing well, bottom 42″ (106.7 cm) x 20″ (50.8 cm)
Bathing well, top 54″ (137.2 cm) x 26″ (66 cm)
To overflow:
Water depth 13-3/4″ (34.9 cm)
Capacity 55 gal (208.2 L)
* Approximate measurements for comparison only.
Model Door maximum
width
Door maximum
height
71120116
71120118
71120126
71120128
57-11/16″ (146.5 cm) 55-1/2″ (141 cm)
Installation Notes
Install this product according to the installation guide.
End stud positioning is critical if nailing-in flanges are used.
Double studding is recommended for pivot shower door
installations.
Attach grab bars at the specified backer board locations only.
2"
(5.1 cm)
75-1/4"
(191.1 cm)
46" (116.8 cm)
1-1/4" (3.2 cm)
33-1/4" (84.5 cm)
3-1/2"
(8.9 cm)
22-1/2"
(57.2 cm)
30" (76.2 cm)
33-1/4"
(84.5 cm)
15-1/2"
(39.4 cm)
8-1/2"
(21.6 cm)
8-1/2"
(21.6 cm)
8"
(20.3 cm)
14" (35.6 cm)
2" (5.1 cm) D. Drain
2" (5.1 cm)
60" (152.4 cm) Min
60-1/8" (152.7 cm) Max
21"
(53.3 cm)
60"
(152.4 cm)
54"
(137.2 cm)
18" (45.7 cm)
4" (10.2 cm)
Back Wall End Wall
Dimensions Taken From
Center of Grout Lines
1" (2.5 cm)
16" (40.6 cm)
20" (50.8 cm)
1"
(2.5 cm)
3-1/2" (8.9 cm)
1" (2.5 cm)
3-1/2"
(8.9 cm)
6" (15.2 cm)
(Typical)
12" (30.5 cm) -
18" (45.7 cm)
Grab Bar
30" (76.2 cm)
Grab Bar
42"
(106.7 cm)
Grab Bar
Note: Right and left end walls are
the same, only mirrored.
Backer board locations
Attachment Block Locations
(Typically 1" (2.5 cm) Inside Grout Lines)
1" (2.5 cm)
2" (5.1 cm)
2-7/8" (7.3 cm)
Overflow
Detail
Product Diagram
ENSEMBLETM
ENSEMBLETM BATH AND WALL SURROUND WITH BACKER BOARDS
Page2of2
1061193-4-
D
/