Chief LCDCP Datasheet

8804-000063 12/10/03

CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: 1-877-894-6918, Email: [email protected]

INSTALLATION INSTRUCTIONS

LCDCP

Ceiling Plate

The Chief LCDCP Ceiling Plate is designed to support Chief RPA and LCDA series mounts.

WARNING:

Improper installation can result in serious personal injury! Make sure that the

ceiling structural members can support a redundant weight factor five times

the

total weight of the equipment. If the ceiling can not support this weight, reinforce

the ceiling before installing the hanger assembly

Maximum 75 pounds.

Unpack and check contents:

Ceiling Plate (1) 5/16-18 Set Screws (1)

Allen Wrench (1)

Installation Instructions

1. Make sure the 1½” pipe nipple is pointing down.

2. Using threaded fasteners through the six 7/16” diameter clearance holes, mount ceiling plate to

appropriate structural ceiling.

3. Thread the 1½” pipe section into the 1½” pipe nipple ceiling plate.

4. Make sure 1½” pipe section is tightly secured into the 1½” pipe nipple.