2. NXT Power
  3. CASE 1
CASE 1

NXT Power CASE 1 Operating instructions

  • Hello! I've reviewed the specification document for the NXT Power wall mount cases. The document specifies the dimensions, tolerances, and manufacturing notes for the CASE 1, CASE 2, and CASE 3 models. It mentions the importance of deburring edges and marking the part information on the inner surface. I'm ready to answer your questions about these cases.
  • What units are the dimensions specified in?
    What should be done to sharp edges?
    Where should the part number and revision be marked?
NOTES:
1. REF 3D CAD DATABASE FOR DIMENSIONAL INQUIRIES
2. ALL PARTS TO BE FREE FROM SHARP EDGES (DEBURR)
3. INK STAMP, ETCH, OR STAMP FINISHED PART # AND REV
ON INSIDE SURFACE OF PART
5.7
4.5
REV ECN CHANGE DESCRIPTION ENGINEER DATE APPROVED
A BRO Mar-11-22
NXT POWER PART NO. CASE 1 WALL MOUNT DIMENSIONS MATERIAL:
DESCRIPTION: FINISH:
INITIATOR: BRO REVISION: A SIZE: D SCALE: 1.000 PAGE: 1 of 3
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN DECIMAL INCHES
TOLERANCES
ANGULAR: MACHINED ±0.5° BEND ± 1°
ONE PLACE DECIMAL: ±.03
TWO PLACE DECIMAL: ±.010
THREE PLACE DECIMAL: ±.005
BREAK SHARP EDGES: .01-.02R
NOTE:
ALL DIMENSIONS IN INCHES
CASE 1
± ° ± °
±
±
±
NOTES:
1. REF 3D CAD DATABASE FOR DIMENSIONAL INQUIRIES
2. ALL PARTS TO BE FREE FROM SHARP EDGES (DEBURR)
3. INK STAMP, ETCH, OR STAMP FINISHED PART # AND REV
ON INSIDE SURFACE OF PART
7.5
4.5
REV ECN CHANGE DESCRIPTION ENGINEER DATE APPROVED
A BRO Mar-11-22
NXT POWER PART NO. CASE 2 WALL MOUNT DIMENSIONS MATERIAL:
DESCRIPTION: FINISH:
INITIATOR: BRO REVISION: A SIZE: D SCALE: 1.000 PAGE: 2 of 3
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN DECIMAL INCHES
TOLERANCES
ANGULAR: MACHINED ±0.5° BEND ± 1°
ONE PLACE DECIMAL: ±.03
TWO PLACE DECIMAL: ±.010
THREE PLACE DECIMAL: ±.005
BREAK SHARP EDGES: .01-.02R
NOTE:
ALL DIMENSIONS IN INCHES
CASE 2
± ° ± °
±
±
±
NOTES:
1. REF 3D CAD DATABASE FOR DIMENSIONAL INQUIRIES
2. ALL PARTS TO BE FREE FROM SHARP EDGES (DEBURR)
3. INK STAMP, ETCH, OR STAMP FINISHED PART # AND REV
ON INSIDE SURFACE OF PART
11.3
6.0
REV ECN CHANGE DESCRIPTION ENGINEER DATE APPROVED
A BRO Mar-11-22
NXT POWER PART NO. CASE 3 WALL MOUNT DIMENSIONS MATERIAL:
DESCRIPTION: FINISH:
INITIATOR: BRO REVISION: A SIZE: D SCALE: 0.333 PAGE: 3 of 3
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN DECIMAL INCHES
TOLERANCES
ANGULAR: MACHINED ±0.5° BEND ± 1°
ONE PLACE DECIMAL: ±.03
TWO PLACE DECIMAL: ±.010
THREE PLACE DECIMAL: ±.005
BREAK SHARP EDGES: .01-.02R
NOTE:
ALL DIMENSIONS IN INCHES
CASE 3
± ° ± °
±
±
±
/