2. RUNGU
  3. Standard
Standard

RUNGU Standard Installation guide

  • Hello! I'm an AI assistant that has read the Rungu Rear Mudguard installation manual. This manual provides instructions for installing and adjusting the mudguard on Rungu Dualie Standard and Juggernaut bikes. I understand the mudguard attaches to the seatpost, replaces the cargo rack, and can be adjusted for optimal protection from mud and water. I'm ready to answer any questions you have based on the information within this document.
  • What tool is required for mudguard adjustments?
    Where does the rear mudguard attach?
    How can I adjust the seatpost grip?
    How should the mudguard be tilted for better protection?
V1.0 Rungu Rear Mudguard installation
Copyright 2022 Standard Bearer Machines, LLC Page 1 of 4
rungu® rear mudguard
installation
The Rungu Rear mudguard installs onto Rungu Dualie Standard and Rungu Juggernaut in lieu of a cargo
rack to keep mud and water from striping your back while riding in wet conditions.
V1.0 Rungu Rear Mudguard installation
Copyright 2022 Standard Bearer Machines, LLC Page 2 of 4
Contents
Tools required ............................................................................................................................................... 2
Preparing the mudguard ............................................................................................................................... 2
Adjusting seatpost grip ................................................................................................................................. 3
Adjusting the mudguard ............................................................................................................................... 4
Tools required
• 3 mm wrench (for adjustment)
Preparing the mudguard
The rear mudguard attaches to the seatpost. To prepare the mudguard, unlatch and open the grip.
V1.0 Rungu Rear Mudguard installation
Copyright 2022 Standard Bearer Machines, LLC Page 3 of 4
Adjusting seatpost grip
The mudguard should have a tight grip on the seatpost so it doesn’t rotate side to side. To adjust the
grip, open the grip and rotate the quick release lever clockwise to tighten and counterclockwise to
loosen.
Repeat the process until you’re satisfied with how the mud flap grips the seatpost.
V1.0 Rungu Rear Mudguard installation
Copyright 2022 Standard Bearer Machines, LLC Page 4 of 4
Adjusting the mudguard
Use a 3 mm wrench to loosen and re-tighten the pivot points to adjust the attitude (in the aeronautical
sense) of the mudguard and height off the rear wheel so that it is 1”-2” above the rear tire. Rungu
recommends tilting the mudguard toward to the front (clockwise) for better protection. Experiment
with adjustments to find what works best for you.
/