FleetSharp Solar Asset Tracker User guide

Brand: FleetSharp

Model: Solar Asset Tracker

Type: User guide

If you need help or have any questions, contact us at 1-844-498-9450 or support@fleetsharp.com

Solar Asset

Tracker

Quick Start Guide

If you need help or have any questions, contact us at 1-844-498-9450 or support@fleetsharp.com

Account and Device Activation

Account Activation

Open your web browser (Chrome is recommended) and go to:

https://activate.eetsharp.com

You will be directed to the Activation Page where you will nish

your account registration. Fill out the following information:

• Activation Code: You can enter either the Activation Code found

on your device OR your Billing Account Number (BAN) provided

in your conrmation email.

• Email Address: Please use the email address you provided when

completing the order.

• Create/Conrm Your Password: Make it strong and secure!

• Read through our Terms & Conditions and then click the radio

box to agree before clicking “Next”.

Welcome to FleetSharp!

This simple step-by-step guide will walk you through activating your account and installing your GPS tracker.

You’ll also nd easy instructions to customize your Customer Portal for tracking vehicles and equipment, mon-

itor reports, set alerts, and much more. Let’s get started!

Welcome to your portal!

• If you entered in your activation code on the previous screen it will

auto populate here.

• If you entered your Billing Account Number (BAN), you will need to

enter the activation code shown on your device here.

Name your tracker based on the naming convention you use to man-

age your vehicles.

• Some common ways to name your vehicle: Blue Truck, Van ##,

Sophie’s Car, Ford F150, Tractor ###, etc.

Enter in any optional information you would like to add for your

tracker.

• Tip! If you are adding trackers into multiple groups, complete Group

Setup before activating the remainder of your devices.

Congratulations! You have now set up your rst device and your por-

tal has been activated for use. From here, you can either choose to

Activate More Trackers or Complete the process and begin using your

system.

Device Activation

If you need help or have any questions, contact us at 1-844-498-9450 or support@fleetsharp.com

Installing Your Solar Asset Tracker

Your solar tracker is set to shipping mode to preserve the battery. Before use, hold down

the black button on the side until you see a light.

The FleetSharp solar asset tracker can be attached to your equipment with magnets

or by using 10-24 x 1 sized screws (not included). ATSolar devices should be mounted

on a at surface.

Do not over tighten and do not bend the device. Do not use glue or other drying

adhesives; they can block a small vent on the back of the tracker. Make sure it is

installed in a location that has access to sunlight.

Weak signal: Installed vertically Limited signal: Installed

under asset

Asset

Install Positioning Matters

Asset

Strong signal: Installed with

clear line to sky

Not Intended For Use:

• Indoors

• Inside of metal casings

• Underground

• In remote, “no cell coverage” areas

Performance and results will vary if used in the above environments.

Solar Tracker Installation

FleetSharp Solar Asset Tracker User guide

FleetSharp Solar Asset Tracker User guide

FleetSharp Solar Asset Tracker User guide

Related papers

Other documents