2. PET
  3. M6-02
M6-02

PET M6-02 User manual

  • Hello! I am an AI chatbot trained to assist you with the PET M6-02 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What are the components of PET M6-02?
    How often should I clean the filter element?
    How often should I clean the water tank, filter element, and water pump?
    What should I do before cleaning the device?
    Where should I place the device?
    What is the pump current, head, and flow?
    What is the capacity of the water tank?
    What is the length of the USB cable?
    What is the material of the device?
    What are the dimensions of the device?
Instruction Manual
M6-02
Intelligent module
This module is configurated in smart version only.Standard Edition does not have this configuration
When the moving object is close to the sensor, it runs automatically, and the delay closes automatically.
Power input
DC5V
Connect to water dispenser
Time adjustment
10 seconds - 5 minutes
General do not tune
installation diagram
People
or
pets
·Avoid direct sunlight
·Avoid water intake
·Avoid wind blowing
Cleaning precautions
-Be sure to do cleannig after disconnecting the power supply.
Not suitable for outdoor use
-For the first time, clean the water tank and accessoriesIt is normal that the filter element may have some
powder. Soak it for 10minutes and rinse it before first use. It is recommended to replace it every4 weeks.
-When the pet water dispenser is used for many pets, thefrequency of the filter element replacement should
be higherPlease clean the water tank, filterelement and water pump regularly according to the water quality
and petdrinking habits. Once a week is recommandedPlease clean the elbow with the cleaning brush come
along, the water tanand other accessories could be cleaned with any cloth.
Submersible pump cleaning method
Dismantle and clean each component weekly as
shown above
Use your nails to enter the waterpanel and pull it out
Regulating water flow
+ Maximum, - Minimum
+
-
Medium recommended
165
Product installation diagram
Submersible pump
DC5V
Keep the water level at a certain
height.Keep flooding the pump.
Water
1.Insert the submersible pump into the pipe under the
cover
2.Assemble all the parts
3.Add water,Plug in the power
Product Description
Features
·Simple structure，easy to clean
·Large capacity，no worry on trip
·Simulation faucet，pet loves
·Ultra quiet pump,≤38db
·Unique water floe direction,no floating hair
·Intelligent module
·Three-layer enhanced filtration·Storage bowl for power failure emergency
Parameter
voltage:DC 5v Pump current:80mA Pump head:0-35cm
Pump flow:120L/H Capacity:2.5L
Size:215*175*125 mm
USB cable:1.5m
Material Working temperature:0-40℃
·Stop automatically in case of water shortage
·Module design,easy to install
(Not standard configuration)
(Not standard configuration)
Weight:700-800g
Packing list
· *Watertank 1
· *Submersible pump&Hose 1
· *Filter 1
· *Lid 1
· *Inner cover 1
· *Induction module 1(Smart version only)
· *Product manual 1
Usage method
3.Add water. Please always keep thewater higher than the submersible
pump, otherwise the pump will be noisyor damaged.
4.When the USB plug is plugged in, the water dispenser starts to work.
2. Install all the components(refer to the Product installation diagram)
1. Take out the water tank and other accessories, For the first time. flush the
water tank ,Filter and all accessories with running water, except for USB
interfaces and adapters.
2 3 4
óOUTlet pipe*1
/