PET M6-02 User manual

Brand: PET

Model: M6-02

Type: User manual

PET M6-02 is an intelligent water dispenser for pets with a 2.5L capacity, featuring a unique water flow direction to prevent floating hair, a three-layer filtration system, and an ultra-quiet pump. Its smart version includes an induction module that automatically starts and stops the water flow when pets are detected. The submersible pump can be easily disassembled and cleaned weekly. The simple structure makes it easy to install and clean, with a storage bowl for power failure emergencies.

Instruction Manual

M6-02

Intelligent module

This module is conﬁgurated in smart version only.Standard Edition does not have this conﬁguration

When the moving object is close to the sensor, it runs automatically, and the delay closes automatically.

Power input

DC5V

Connect to water dispenser

Time adjustment

10 seconds - 5 minutes

General do not tune

installation diagram

People

pets

·Avoid direct sunlight

·Avoid water intake

·Avoid wind blowing

Cleaning precautions

-Be sure to do cleannig after disconnecting the power supply.

Not suitable for outdoor use

-For the ﬁrst time, clean the water tank and accessoriesIt is normal that the ﬁlter element may have some

powder. Soak it for 10minutes and rinse it before ﬁrst use. It is recommended to replace it every4 weeks.

-When the pet water dispenser is used for many pets, thefrequency of the ﬁlter element replacement should

be higherPlease clean the water tank, ﬁlterelement and water pump regularly according to the water quality

and petdrinking habits. Once a week is recommandedPlease clean the elbow with the cleaning brush come

along, the water tanand other accessories could be cleaned with any cloth.

Submersible pump cleaning method

Dismantle and clean each component weekly as

shown above

Use your nails to enter the waterpanel and pull it out

Regulating water ﬂow

+ Maximum, - Minimum

Medium recommended

165

Product installation diagram

Submersible pump

DC5V

Keep the water level at a certain

height.Keep ﬂooding the pump.

Water

1.Insert the submersible pump into the pipe under the

cover

2.Assemble all the parts

3.Add water,Plug in the power

Product Description

Features

·Simple structure，easy to clean

·Large capacity，no worry on trip

·Simulation faucet，pet loves

·Ultra quiet pump,≤38db

·Unique water ﬂoe direction,no ﬂoating hair

·Intelligent module

·Three-layer enhanced ﬁltration·Storage bowl for power failure emergency

Parameter

voltage:DC 5v Pump current:80mA Pump head:0-35cm

Pump ﬂow:120L/H Capacity:2.5L

Size:215*175*125 mm

USB cable:1.5m

Material Working temperature:0-40℃

·Stop automatically in case of water shortage

·Module design,easy to install

(Not standard conﬁguration)

Weight:700-800g

Packing list

· *Watertank 1

· *Submersible pump&Hose 1

· *Filter 1

· *Lid 1

· *Inner cover 1

· *Induction module 1(Smart version only)

· *Product manual 1

Usage method

3.Add water. Please always keep thewater higher than the submersible

pump, otherwise the pump will be noisyor damaged.

4.When the USB plug is plugged in, the water dispenser starts to work.

2. Install all the components(refer to the Product installation diagram)

1. Take out the water tank and other accessories, For the ﬁrst time. ﬂush the

water tank ,Filter and all accessories with running water, except for USB

interfaces and adapters.

2 3 4

óOUTlet pipe*1

PET M6-02 User manual

PET M6-02 User manual

Other documents